Loading ...
Loading ...
Loading ...
Consumer Support
Troubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions
15
Problem Possible Causes What To Do
Air conditioner The air conditioner • Make sure the air conditioner plug is pushed completely
does not start is unplugged. into the outlet.
The fuse is blown/circuit • Check the house fuse/circuit breaker box and replace
breaker is tripped. the fuse or reset the breaker.
Power failure. • The unit will automatically re-start in the settings last
used after the power is restored.
• There is a protective time delay (approximately
3 minutes) to prevent tripping of the compressor
overload. For this reason, the unit may not start
normal cooling for 3 minutes after it is turned
back on.
The current interrupter • Press the RESET button located on the power cord plug.
device is tripped.
• If the RESET button will not stay engaged, discontinue
use of the air conditioner and contact a qualified service
technician.
Air conditioner does not Airflow is restricted. • Make sure there are no curtains, blinds or furniture
cool as it should blocking the front of the air conditioner.
The temp control may not • On models with touch pads: In COOL mode, press the
be set correctly. DECREASE ▼pad.
• On models with control knobs, turn the temperature
knob to a higher number.
The air filter is dirty. • Clean the filter at least every 30 days.
See the Operating Instructions section.
The room may have been hot. • When the air conditioner is first turned on, you need to
allow time for the room to cool down.
Cold air is escaping. • Check for open furnace floor registers and cold air returns.
• Set the air conditioner’s vent to the closed position.
Cooling coils have iced up. • See “Air conditioner freezing up” below.
Air conditioner Ice blocks the air flow and • On models with control knobs, set the mode control at
freezing up stops the air conditioner HIGH FAN or HIGH COOL with the temp at 1 or 2.
from cooling the room.
• On models with touch pads, set the controls at
HIGH (F3) FAN or HIGH (F3) COOL and set the thermostat
to a higher temperature.
The remote control The batteries are inserted • Check the position of the batteries. They should be
is not working incorrectly. inserted in the opposite (+) and (–) direction.
The batteries may be dead. • Replace the batteries.
Water drips outside Excessively hot and • This is normal.
humid weather.
Water drips indoors The air conditioner is not • For proper water disposal, make sure the air conditioner
tilted to the outside. slants slightly from the case front to the rear.
Water collects in Moisture is removed from • This is normal for a short period in areas with little
base pan indoor air and drains into humidity; normal for a longer period in very humid areas.
rear of a cabinet where a fan
blows it against the outdoor
condenser coil.
TIMER feature not A power outage or interruption • In the case of a power outage or interruption, the unit
working properly occurred. TIMER feature will reset to the original setting. You may
need to set a new time if desired.
Troubleshooting Tips.
ge.com
Troubleshooting Tips. Save time and money! Review the chart below
first and you may not need to call for service.
Loading ...
Loading ...
Loading ...