Loading ...
Loading ...
Loading ...
,
CAUTION: Before installation or
servicing, disconnect the power
supply by either removing the fuse,
shutting off the main power or
manually "tripping" the circuit
breaker.
Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous and
the manufacturer will not be held
responsible.
Before connecting the appliance to
the power supply, make sure that
the voltage and frequency listed on
the rating label correspond with the
household electrical supply. This
data must correspond to prevent
appliance damage. Consult an
electrician if in doubt.
Only operate the appliance after it
has been installed into the
countertop.
Installer:
Please leave these instructions with
the consumer.
Power supply
^
Be sure your electrical supply
matches the data plate.
The rating label is located on the
underside of the appliance.
The appliance is equipped with a
flexible metal conduit encasing 3 wires
ready for connection to a grounded
power supply.
It must be connected to a dedicated
line through the use of an approved
junction box.
If the machine is hard wired a separator
switch with a contact gap of at least
3 mm must be provided (including
switch, fuses and relays). All
components must be CSA or UL
approved.
Black wire: connect to L1 (hot)
Red wire: connect to L2 (hot)
Green wire: connect to GND (ground)
KM 5621:
208 V, 60 Hz, 40 A fuse rating
240 V, 60 Hz, 30 A fuse rating
KM 5624:
208/240 V, 60 Hz, 40 A fuse rating
KM 5627:
208/240 V, 60 Hz, 50 A fuse rating
Be sure the power outlet is accessible
after installation.
For further information, see the wiring
diagram provided with the appliance.
, WARNING:
THIS APPLIANCE MUST BE
GROUNDED!
Electrical connection
33
Loading ...
Loading ...
Loading ...