LTN19315SW User Manual

Loading ...

• At this point, remove the Decorative Bolt on bottom on

refrigerator housing from the left side of refrigerator

(See Figure 14). You will need this hole for the Bottom

Hinge.

• Move the Bottom Hinge to the left side of housing

keeping the same orientation, and reattach with three

bolts (Figure 15). Now move decorative bolt to hole on

lower right side of housing.

• Turn refrigerator door upside down on a non-

scratching surface.

• With door upside down, loosen the 2 screws and

remove the door closer (stop) (See Figure 16), then

loosen the other two screws to remove the bottom

Hinge Pin Insert Bracket with Hinge Pin Insert (Figure

17).

NOTE: The Refrigerator door closer (stop) is not used on

all models. The model you have may not include this

part.

• Take out the Hinge Pin Insert and move the Bracket

to the other side of the door, keeping the same

orientation (See Figure 17).

• Place Hinge Pin Insert into the left side of the bracket,

tighten Hinge Pin Bracket to door (Figure 18).

• Take Door Closer/stop and ﬂip (See Figure 19). Line

up screw holes and mount on left side of door bottom

with the two screws. Turn door upright. It is now ready

for reattaching.

REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION

Fig. 15

Fig. 14

Fig. 16

Door Closer (Stop)

Fig. 17

Hinge Pin Bracket

Hinge

Insert

Hinge Pin

Bracket

Hinge

Insert

Fig. 18

Fig. 19

Door Closer (Stop)

Decorative

Bolt

Fig. 13

Loading ...

User Manual - Page 14