Loading ...
Loading ...
Loading ...
9
First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Possible Causes
Solution
Feet may not be in contact
with the oor and locked.
Front and rear feet must be in rm contact with oor, and
washer must be level to operate properly. Jam nuts must be
tight against the bottom of the cabinet.
Washer may not be level.
Check oor for exing or sagging. If ooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
TROUBLESHOOTING
Check the following
for proper installation:
Check the following
for proper installation:
Washer not level.
Water Leaks
Vibration or Off-Balance
See “Level the Washer.”
Water may splash off basket if washer is not level.
Fill hoses not attached tightly. Tighten ll hose connection.
Washer won’t run or ll,
washer stops working,
or wash light remains
on (indicating that the
washer was unable to
ll appropriately)
Check for proper water supply. Both hoses must be attached and have water owing to inlet valve.
Both hot and cold water faucets must be turned on.
Incorrect or wrong wash
or rinse temperatures,
or load not rinsed
Check for proper water supply.
Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached to both the washer and the faucet,
and have both hot and cold water owing to the inlet valve.
Washer not draining/
spinning, loads are
still wet or spin light
remains on (indicating
that the washer was
unable to pump out
water within ten
minutes)
Check plumbing for correct drain
hose installation. Drain hose extends
into standpipe farther than 4.5"
(114 mm).
Check drain hose for proper installation. Use drain hose form
and securely attach to drain pipe or tub. Do not tape over drain
opening. Lower the drain hose if the end is higher than 96"
(2.4 m) above the oor. Remove any clogs from the drain hose.
Fill hose washers. Make sure all four ll hose at washers are properly seated.
Drain hose connection. Pull drain hose from washer cabinet and properly secure it
to drain pipe or laundry tub.
Check household plumbing for
leaks or clogged sink or drain.
Water can back up out of a clogged sink or drain pipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water
pipes, and faucets.)
Washer not performing as expected
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water ow.
Check for proper electrical supply.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Make sure there is power to the outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Both hot and cold water faucets must be on.
Make sure that inlet valve screens are not clogged.
Remove any kinks in the hoses.
Loading ...
Loading ...
Loading ...