Loading ...
Loading ...
Loading ...
13
Setting the amount of rinse aid used
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
1 Press the [On/Off] button.
2 Hold down the “A” button (see page 17) and press [Start] until the
display indicates “d:00”. Release both buttons.
3 Press the “A” button until the display shows “r:05”.
4 Press the “C” button to select the desired setting.
“r:00” = dispenser is OFF
“r:01” = lowest setting
“r:02” = low setting
“r:03” = medium setting
5 Press [Start] to save the setting.
Note: Using rinse aid and setting the dispenser to “r:00” may result in longer
cycle times.
Water Softener
Your water hardness level directly impacts your dishwasher's perfor-
mance. Hard water will increase spotting and reduce detergent perfor-
mance. This dishwasher is equipped with a water softener that uses a
special salt to adjust the water hardness to obtain optimal performance.
The dishwasher salt is added to the salt chamber located under the
lower dishwasher rack. The amount of salt that is dispensed is based on
your home water hardness. The home water hardness can be determined
by using the water hardness test strip included in your manual set (or
from your local hardware store). The dishwasher water softener setting
must be adjusted to match your water hardness.
For the water softening system to function properly, you will need to use the
dishwasher water softening salt. The amount of salt dispensed can be set
from “H:00” to “H:07”. Salt is not required at H:00 (this is the default factory
setting). The amount of salt required depends on the degree of hardness of
your tap water. See Hard Water and your Dishwasher Table on next page.
To use the provided water hardness test strip see below.
1 Hold down the “A” button (see page 17) and press [START] until
the display indicates “H:00”.
2 Release both buttons. Press the “C” button to select the desired
setting.
3 Save the selected setting by pressing [START].
“r:04” = medium/high setting
“r:05” = high setting
“r:06” = highest setting
Loading ...
Loading ...
Loading ...