Loading ...
Loading ...
Loading ...
106
MAINTENANCE
Seat Removal
1. Locate the seat removal
latch in the center of the
seat’s rear.
2. Pull on the latch handle to
disengage the seat from
the vehicle’s frame.
3. Remove the seat.
Elevating the Vehicle
for Service
Some service procedures
require elevation of the
vehicle. Always position
the vehicle on a firm,
level surface before
elevating. Do not position
a jack or jack stand under
any components other
than the frame.
Use an appropriate lift or
floor jack. This vehicle is
not equipped with
dedicated jacking points. Place the floor jack at the front (or rear) of the
vehicle, directly under the center of the unit. Make sure the floor jack
makes contact only with the frame of the vehicle while lifting.
Do not allow the vehicle to remain elevated on a floor jack. After elevat-
ing, place jack stands under the frame on each side of the floor jack,
then lower the floor jack.
Jack Stands
Elevate at Center
Loading ...
Loading ...
Loading ...