Loading ...
Loading ...
Loading ...
14
INSTALLATION OF EMB2527BA
CAUTION!
Do not block the air vents. If you do that, the appliance
can overheat.
CAUTION!
Do not connect the appliance to adapters or extension leads.
This can cause overloading and risk of fire.
• Model EMB2527BA is for built-in use only.
• The fitted cabinet must not have a back wall behind
the appliance.
• Put the appliance far away from steam, hot air and
water splashes.
• If the appliance is stored/ transported at sub-zero
temperatures, do not activate it immediately after
installation. Allow at least two hours for it to be brought
up to room temperature before turning on the unit.
Installation - Built-in model EMB2527BA
For the best integration within a kitchen, install this
appliance in a standard 600mm wide cupboard that gives
a flush fit with the surrounding cupboard fronts. A recess
of 20mm is ideal.
The built-in cabinet must not have a rear wall behind
the appliance. Do not cover ventilation slots and air
intake points.
NOTE: Your appliance must be mounted on a flat surface
for the full width and depth of the product.
Built-in furniture – flush fit
600mm
396mm
(+2)
Min. 850mm
from floor
to base of
microwave
oven.
Min.
550mm
45mm
A 45mm ventilation gap must be left between the built-in
cabinetry and wall with no back panelling on the cabinet
housing the microwave oven. A ventilation gap of min.
3.5mm must be left between the bottom of the front trim
and adjacent shelf/cupboard).
Failure to accommodate for this gap in the installation
can cause product malfunctions which are not covered
under warranty.
Side view
45mm
9mm packer
Please note
packer must be
set back 20mm
from front trim to
avoid obstruction
of front vent.
Packer must be
secured to base
of cabinet.
microwave
oven
20mm
External face
of cabinet
and/or door
Min 3.5mm
ventilation gap
below trim
Flush fit top view
infill panel
20mm
600mm
Cupboard
door
Cupboard
door
Infill panels are recessed 20mm from the external cabinet
door to accommodate flush fit.
Loading ...
Loading ...
Loading ...