User Manual - Page 25

For GSS25WGMDCC.

Loading ...
Loading ...
Loading ...
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT – Save these
instructions for local inspector’s use.
IMPORTANT – Observe all
governing codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions
for future reference.
Skill level – Installation of this appliance requires
basic mechanical skills.
Completion time – Refrigerator Installation
15 minutes
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the Warranty.
Do not install the refrigerator where the temperature
will go below 16°C because it will not run often enough
to maintain proper temperatures.
Do not install the refrigerator where the temperature
will go above 37°C because it will not perform properly.
Install it on a floor strong enough to support it fully
loaded.
REFRIGERATOR LOCATION
Installation
Refrigerator
Instructions
Models 21, 23, 25, 27 & 29
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections:
CLEARANCES
If the refrigerator has an icemaker, it will have
to be connected to a cold water line. An approved
water supply kit is available at extra cost from your
local distributor.
Maximum permissible inlet water pressure–8.2 bars.
Minimum permissible inlet water pressure–2.8 bars.
Installation of the icemaker must be done by a
qualified service technician.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS
)
21 and 23 25, 27 and 29
Sides 4 mm 4 mm
Top 25 mm 25 mm
Back 13 mm 25 mm
25
29 27 25 23 21
A* 1733 mm 1733 mm 1733 mm 1733 mm 1733 mm
B 908 mm 908 mm 908 mm 908 mm 908 mm
C** 912 mm 879 mm 879 mm 738 mm 738 mm
D 1261 mm 1271 mm 1271 mm 1156 mm 1156 mm
E 1273 mm 1255 mm 1247 mm 1232 mm 1214 mm
F 1051 mm 1093 mm 1099 mm 989 mm 986 mm
G 1386 mm 1381 mm 1381 mm 1361 mm 1355 mm
H 1140 mm 1150 mm 1149 mm 1023 mm 994 mm
*Height does not include hinge.
**Depth includes handle.
DIMENSIONS
A
B
C
D
F
E
H
G
Loading ...
Loading ...
Loading ...