Loading ...
Loading ...
Loading ...
Unplug vacuum, turn over and unscrew
six (6) Philips head screws to remove
the bottom cover.
Clean debris from
brush roll. Inspect
by placing it on its
end and spin. The
brush roll should
spin freely, multiple
times by one flick.
If it doesn’t, replace
brush roll.
Check belt for wear
or cuts and replace
if necessary.
Thread belt and line up
End Cap to reassemble
roller. Replace bottom
cover and 7 screws.
End Cap
Belt
Maintenance: Replace Brush & Belt
Twist gray collar
counter clockwise,
until slot appears,
then separate
faceplate.
Paddle Wheel
Roller
Belt
1
2
3
NOTE: If an object becomes lodged in foot and brush shuts o, turn vacuum o and
unplug from electrical outlet. Remove obstruction and brush will automatically reset when
vacuum is plugged and turned back on.
www.BISSELL.com
9
1
2
3
Maintenance: TurboBrush
®
& TurboEraser
®
Tool
Align
Slot
Remove brush roll,
belt, and paddle
wheel. Inspect
for damages and
replace if necessary.
To reassemble, align two clips on each
end of paddle wheel with belt on and
pop back into place.
Place brush roll with belt back in.
Faceplate will not close properly if all
parts are not aligned correctly.
Paddle Wheel End
Clip
Loading ...
Loading ...
Loading ...