Loading ...
Loading ...
Loading ...
H
FLOW SENSE™ DUCT BLOCKAGE
SENSING SYSTEM INDICATOR
The FLOW SENSE™ duct blockage sensing
system detects and alerts you to blockages
in the ductwork that reduce exhaust flow
from the dryer. This improves operating
efficiency and helps minimize service calls,
saving you money.
THE LCD DISPLAY (cont.)
THE DUCTWORK HAS
A BLOCKAGE THAT NEEDS
TO BE REMOVED
IMMEDIATELY.
NEED FLOW CHECK
If no bars are shown in the
display, the ductwork is free from
blockages.
If two bars in the display are
lighted, examine the dryer
exhaust system for lint build up
or other restrictions, including
damage, excess length, foreign
objects, etc. See note below.
If all bars are lit, the dryer
ductwork has a blockage
that needs to be removed
immediately.
2 bars are displayed In the LCD screen.
•Ductworkisslightlytoolongorhastoo
many turns/restrictions.
•Partialblockageofthe
ductwork due to lint
buildup.
1. Possible causes
•Installashorterorstraighterductrun.See
the Installation Instructions.
•Ductworkshouldbechecked/cleanedsoon.
Dryer can be used in this condition, but
drying times may be longer.
•IfENDOFCYCLEisdisplayedaftertheend
of cycle, it will be off in 4 minutes. If POWER
button is pressed or the door is opened,
power will be off immediately.
2. Solutions
NOTE: If the duct has been checked and
cleaned and two bars are still displayed after
several cycles, then there is some restriction
in the duct due to length, condition, etc. In
this case, no further action is necessary and
the dryer can be used normally. However,
drying times may be increased and there may
be some reduction in operating efficiency
4 bars are displayed In the LCD screen.
•Ductworkistoolongorhastoomanyturns/
restrictions.
•Signicantblockageoftheductworkdueto
lint buildup or debris.
1. Possible causes
•Installashorterorstraighterductrun.See
the Installation Instructions.
•Ductworkshouldbechecked/cleanedsoon.
Dryer can be used in this condition, but
drying times may be longer.
•IfNEEDFLOWCHECKisdisplayedafter
the end of cycle, it will be off in 2 hours. If
POWER button is pressed or the door is
opened, power will be off immediately.
2. Solutions
END OF CYCLE
32
MFL67408107_en_110930.indd 32 2011.9.30 5:48:22 PM
Loading ...
Loading ...
Loading ...