Loading ...
Loading ...
Loading ...
13
Product Care
Cleaning & Maintenance
Glass Shelves
To clean your refrigerator’s glass shelves, lift the shelf out by lifting the
front and releasing the hooks from the metal track. Then pull the shelf
out. Be sure to allow the glass shelves to adjust to room temperature
before cleaning. Use a mild detergent with water to clean. Dry glass
shelf thoroughly and replace shelf by inserting hooks into metal track
and lowering front.
Door Gaskets
Clean the door gaskets every three months using the same procedures used for interior surfaces. You should apply a light lm of
petroleum jelly to keep gaskets pliable.
CAUTION
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break suddenly
if nicked, scratched, or exposed to sudden temperature
change.
Condenser Cleaning Indicator
The refrigerator temperature display will be blinking “CL” to indicate that it is time to clean the condenser coil.
Condenser Cleaning:
There is always chance of getting the condenser clogged due to dust in the air, pet hair, etc. We recommend cleaning the condenser
once every 6 months. It is always better to clean the condenser coil as soon as you perform any construction activities, or work that
produce lots of dusts near the unit.
To clean the condenser:
1. Turn o the main power switch located at the top of unit behind the top access panel as shown in Settings and Functions – Power
On/O switch page 6.
6. Replace the access panel and kick plate.
7. Turn main power switch on. Replace top access panel.
8. Reset and remove the “CL” from the temperature display by simultaneously pressing the up and down arrow key for 3 seconds.
2. Remove the bottom freezer drawer by pulling all
the way out, removing the rear clips and lifting
out. Details are shown in the freezer section page
10.
3. Remove the kick plate by loosening two screws and slide out
though the key hole
4. Remove the access panel by removing 2
screws as shown here and pull out with force
to unsnap the panel
5. Vacuum the front surface of the condenser coil using any house hold
vacuum cleaner extension. It is recommended to vacuum the coil
rather than using any duster. Duster may damage the n. Make sure to
remove the dust completely out of the coil area.
Loading ...
Loading ...
Loading ...