Loading ...
Loading ...
Loading ...
Page:
10
User Manual:
Tips
WARM TIPS
→ The refrigerator enclosure may emit heat during operation specially in summer, this is
caused by the radiation of the condenser, and it is a normal phenomenon.
→ Condensation: Condensation phenomenon will be detected on the exterior surface
and door seals of the refrigerator when the ambient humidity is large, this is a normal
phenomenon, and the condensation can be wiped away with a dry towel.
→ Buzz: Buzz will be generated by running compressor specially when starting up or shutting
down.
TIPS FOR ENERGY SAVING
→ Try not to open the door too often, especially when the weather is wet and hot. Once you
open the door, close it as soon as possible.
→ Every now and then check if the appliance is suciently ventilated (adequate air circulation
behind the appliance).
→ In normal temperature conditions, please arrange the thermostat at the middle setting.
→ Before loading the appliance with packages of fresh food, make sure they are cooled to
ambient temperature.
→ Ice and frost layer increase energy consumption, so clean the appliance as soon as the
layer is 3-5 mm thick.
→ If it is the outer condenser, the rear wall should be always clean free of dust or any
impurities.
→ The appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
→ Let hot foods cool to room temperature before placing in the appliance. Overloading the
appliance forces the compressor to run longer. Foods that freeze too slowly may lose
quality, or spoil.
→ Be sure to wrap foods properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside the appliance.
→ Appliance storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the appliance less ecient.
→ Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
DISPOSAL
→ Old units still have some residual value. An environmentally friendly method of disposal will
ensure that valuable raw materials can be recovered and used again. The refrigerant used
in your unit and insulation materials require special disposal procedures. Ensure that none
of the pipes on the back of the unit are damaged prior to disposal. Up to date informa on
concerning op ons of disposing of your old unit and packaging from the new one can be
obtained from your local council oce.
→ When disposing of an old unit break of any old locks or latches and remove the door as a
safeguard.
→ Correct Disposal: This marking indicates that this product should not be
disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return
and collec on systems or contact the retailer where the
product was purchased. They can take this product for
environmental safe recycling.
For more information, please contact the local authority or your retailer where you purchased the product.
Loading ...
Loading ...
Loading ...