SCRAMBLER XP 1000 EPS [QUAD L7E] User Manual

Loading ...

1. Remove the upper headlight pod.

2. Loosen the four handlebar bolts.

3. Adjust the handlebar to the desired height. Be sure the handlebars do not

contact the gas tank or any other part of the machine when turned fully to the

left or right.

4. Torque the front two bolts to specification, then torque the rear two bolts. A

gap of up to 1/8" (3 mm) will remain at the rear of the clamp blocks.

TORQUE

Handlebar bolts:14 ft-lbs +/- 10% (19 Nm +/- 10%)

5. Reinstall the headlight pod.

CLEANING AND STORAGE

WASHING THE VEHICLE

NOTICE

The use of a high pressure washer may damage the instrument cluster. Wash

the vehicle by hand or with a garden hose using mild soap. Do not use alcohol

to clean the instrument cluster. Do not allow insect sprays to contact the lens.

Immediately clean off any gasoline that splashes on the instrument cluster.

If a high pressure water system is used for cleaning (not recommended),

exercise extreme caution. The water may damage components and could

remove paint and decals. Avoid directing the water stream at the following items:

• Wheel bearings

• Radiator

• Transmission seals

• Cab and body panels

• Electrical components

• Switches and controls

• Fuel system components

• Labels and decals

If an informational or graphic label becomes illegible or comes off, contact your

POLARIS dealer to purchase a replacement. Replacement safety labels are

provided by POLARIS at no charge.

Grease all zerk fittings immediately after washing. Allow the engine to run for a

while to evaporate any water that may have entered the engine or exhaust

system.

127

MAINTENANCE

Loading ...

Polaris Scrambler XP 1000 S SCRAMBLER [QUAD L7E]