Loading ...
Loading ...
Loading ...
5. Production troubleshooting and maintenance instruction
(1)Electrical fault
1. The safety switch does not work:
（
1
）
Check whether the safety switch is in good condition;
（
2
）
Check whether the safety switch is in the closed state.
For orange juicer , pressure safety switch button form the top of the cover .
2. The starting switch does not work:
（
1
）
Check whether the starting switch is in good condition;
（
2
）
Check whether the starting switch socket end is plugged.
3. Motor does not work:
（
1
）
Check whether the socket at the two sides of the power line is tightened;
（
2
）
Check whether the fuse is in good condition;
（
3
）
Check whether the terminal in the motor switch box is solid connection.
（
2
）
Mechanical failure:
1. The motor output shaft end bevel gear wheel transmission mesh:
（
1
）
Check whether the size of bevel gear wheel is damaged;
（2）Check whether the meshing positions of the big and small bevel gears wheel are correct, the
adjustable small bevel gears wheel is rising to the correct meshing position and tighten the hex
screws on the gear( when the small bevel gear wheel on the motor shaft position is moved
down).
2. The damage of transmission cylindrical gear
(1) The size of transmission cylindrical gear is divided into a pair of large cylindrical gear
(Z = 52), a pair of small cylindrical gear (Z = 39).
(2) Iron gear is generally is tooth form damage
(3) If the cylindrical gear transmission has abnormal sound, it can be judged that the cylindrical
gear is damaged, in the initial stage of the gear damaged, the machine work must be stopped
immediately, the damaged gear must be replaced, otherwise it will affect the relative position of
the working parts of machine, thus aggravates the damage of the gear, and until damage the
electrical machine and the working surface of the and concave and convex balls.
Replace the method of cylindrical gear:
A. Remove the damaged cylindrical gear and the elated parts according to the assembly sequence
B. Use two square hole templates lock the upper two of four corner angle shaft parallels( figure 1), and
then install two big cylindrical gears
Loading ...