Loading ...
Loading ...
Loading ...
Using your Sunbeam Iron
Before first use
Remove any adhesive stickers, covers or
cardboard sleeves from the soleplate.
Fill the water tank and empty the water.
This will rinse out any foreign
particles remaining in the water tank
from the manufacturing process.
NOTE: When turned on for the first time,
your new iron may give off vapours for
up to 10 minutes. This is due to the
initial heating of the materials used. It
is safe and not detrimental to the iron.
Filling the iron with water
Before filling the iron with water ensure
the power is turned off and the plug is
removed from the power outlet. The iron
can be filled with water while it is hot.
Slowly pour water into the water inlet
until the maximum water level is reached.
Do not exceed the maximum water level
indicator. Close the water inlet cover
NOTE: The soleplate design allows you to
use tap water without affecting the steam
performance. However in very hard water
areas, Sunbeam recommends the use of
distilled water, or water which has been
demineralised.
Do not fill the iron with fabric conditioner,
starches or any other solution as these will
damage the steam mechanism. Do not use
contaminated water.
Using your iron
1. Insert the plug into a 220-240 volt
power outlet and turn the power on.
2. Turn the temperature dial to the desired
setting by aligning the setting on the
dial with the temperature indicator.
The thermostat light on the SR6300
Sunbeam Sprint iron, will illuminate to
indicate that the iron is heating. When
the thermostat light goes out the iron has
reached the selected temperature and
is ready to iron.
NOTE: When the temperature dial is
changed from a high setting to a lower
temperature setting during ironing, the
thermostat light on the SR6300 Sunbeam
Sprint iron, will go out immediately to
indicate the iron is cooling. To ensure
that the iron has reached the selected
temperature and is not too hot, wait until
the thermostat light comes on again
and then goes out before ironing.
NOTE: When steam ironing, ensure that the
temperature dial is set to any temperature
within the steam band and that the tank is
at least ¼ full of water.
Using the shot of steam
The shot of steam can be used whether dry
or steam ironing when the temperature dial
is set to any temperature above the two dot
(••) setting.
1. Ensure the water tank is at least ¼
full.
2. Select the temperature and wait until
the thermostat light on the SR6300
Sunbeam Sprint iron goes out.
3. Press the shot of steam button several
times with the iron on the soleplate to
prime the pump.
NOTE: If the tank has run dry, it may be
necessary to re-prime the pump after filling
the iron with water.
Using the spray mist
The spray mist can be used whether dry
or steam ironing to pre-dampen hard to
iron fabrics.
1. Ensure water the tank is at least ¼
full.
2. Press the spray button during ironing
to release a fine mist from the nozzle.
8
Loading ...
Loading ...
Loading ...