Loading ...
Loading ...
Loading ...
en
7
Aligning the appliance
To ensure that the appliance functions correctly, it must
be set level with a spirit level.
Ø For sufficient leveling and air circulating in the lower
rear section of the appliance, the bottom feet may
need to be adjusted.
Ø To allow the doors to selfclose, tilt back the top
backwards at about 15 mm or 0.5° by turning the
adjustable feet.
Ø Whenever you want to move the appliance,
remember to turn the feet back up, so that the
appliance can roll freely.
Ø The rollers, which are not castors, should be only
used for forward or backward movement. Moving
the refrigerator sideways may damage your floor
and the rollers.
Ø Reinstall the appliance when relocating.
0.5°
adjustable bottom feet
Connecting the appliance
Have a technician install and connect the appliance
according to the enclosed installation instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until the
appliance has been installed.
Apart from statutory national regulations, you should
stick to the connection terms relating to the local
electricity company.
After installing the appliance, wait at least 1 hour until
the appliance starts up. During transportation the oil in
the compressor may have flowed into the refrigeration
system.
Before switching on the applianceforthefirsttime,
clean the interior of the appliance
(~ chapter “Cleaning the appliance”).
Electrical connection
: Warning - Risk of electric shock!
If the length of the mains cable is inadequate, never
use multiple sockets or extension leads. Instead,
please contact Customer service for a lternatives.
The appliance must be connected to a permanently
installed socket.
The socket must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with protection class I.
Connect the appliance to 220-240 V / 50 Hz alter
nating current via a correctly installed socket with
protective conductor. Thesocketmustbeprotected
by a 10 A to 16 A fuse or higher.
For appliances operated in non-European countries,
check whether the indicated voltage and current type
match the values of your electricity supply. The rating
plate is situated in the bottom right-hand side of the
appliance. The mains cable may be replaced by a
technician only.
: Warning
Never connect the apliance to electronic energy saver
plugs.
Our appliances can be used with mains and sine-
controlled inverters. Mains-controlled inverters are used
for photovoltaic systems which are connected directly
to the national grid. Sine-controlled inverters must be
used for isolated applications (e.g. on ships or in
mountain lodges) which are not connected directly
to the national grid.
Loading ...
Loading ...
Loading ...