Loading ...
Loading ...
Loading ...
19
En
Preparation
05
English
Installation
• The speaker is wide, and may become unstable when installed
by a one person alone. This may result in injury or product
damage. Therefore, at least two people must assemble and
install it.
• When installing the speaker, do not use any screws other than
those supplied, otherwise the speaker may come off from the
main unit and fall over.
• When installing the speaker, tighten the screws firmly.
Note
• Before attaching the speaker, please attach the table top stand
to the plasma display unit.
1 Attach the speaker mounting fittings to the rear
of the plasma display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the plasma display using
the supplied screws.
• Finger tighten the two screws in the order followed by .
• Attach the center fitting to the lower center on the rear
panel of the plasma display using the two supplied screws.
• Tighten the two screws in the order , as shown in the
drawing.
• When fitting the screws, place screws and through
the holes in the center fitting.
Note
• See page 22 for speaker mounting procedures when using the
hung on wall unit.
Speaker
PDP-6010FD with the speaker installed
(with the Pioneer table top stand)
Speaker mounting fitting
(left side)
Speaker mounting fitting
(center)
Speaker cable
Speaker mounting fitting
(right side)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
1
2
Speaker mounting fitting for the left side
(the fitting method is the same as the
fitting for the right side)
Speaker mounting
screw (M5 x 10 mm)
Label “L” is affixed to the
left side fitting. (Similarly,
label “R” is affixed to the
right side fitting.)
1
2
Speaker mounting fitting for
center
Speaker mounting screw
(M5 x 10 mm)
Loading ...
Loading ...
Loading ...