Loading ...
Loading ...
Loading ...
15
SERVICING
Always disconnect the appliance from the electric and gas supplies before proceeding with
any servicing operation.
Replacing Components
To replace the components housed inside the appliance, remove the trivets and the burners from the upper
part of the cooktop. Remove the fixing screws "V" of the burner (Fig. 13) and the knobs using hand pressure
to remove them from the appliance.
After having carried out these operations, the burners (Fig. 14), taps (Fig. 15) and electrical components can
all be replaced (Fig. 16).
It is advisable to change seal "D" (Fig. 15) whenever a tap is replaced to ensure a perfect tightness.
Greasing the taps (See Fig. 17-18)
If a tap becomes stiff to operate, it must be immediately greased in compliance with the following
instructions:
1.
Remove the tap.
2.
Clean the cone and its housing using a cloth soaked in solvent.
3 .Lightly grease the cone.
4 .Fit the cone back into place, operate it a few times and then remove it again. Eliminate any excess
grease and check that the gas ducts have not become clogged.
5.
Fit all parts back into place, following the disassembly order in reverse.
6.
The tight closure test must be done using a foaming liquid.
Never use a flame for this test.
WARNING:
MAINTENANCE MUST ONLY BE PERFORMED
BY AUTHORIZED PERSONS.
FIG. 13
FIG. 14
FIG. 15
FIG. 16
FIG. 17
FIG. 18
Loading ...
Loading ...
Loading ...