Loading ...
Loading ...
Loading ...
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes before
turning it back on. This keeps the air conditioner from blowing a
fuse or tripping a circuit breaker.
■ Do not try to operate your air conditioner in the Cool mode when
outside temperature is below 61°F (16°C). The inside evaporator
coil will freeze up, and the air conditioner will not operate
properly.
AIR CONDITIONER USE
Starting Your Air Conditioner
6
Operating your air conditioner properly helps you
to obtain the best possible results.
This section explains how to operate this air
conditioner.
IMPORTANT:
STARTING THE AIR CONDITIONER
cont.
•
When you turn off the air conditioner , either at the
control panel or with the remote control,wait at
least 3 minutes before turning it back on. This
prevents the compressor from overloading. This 3
minute delay also applies when switching from cool
mode to fan and back.
•
Do not operate your air conditioner in the Cool
mode when the outside temperature is below
61°F
(16° C). The inside evaporator coil will freeze up, and
the air conditioner will not operate properly.
1. Carefully remove the clear plastic film from the
control panel.
2. rP ess POWER once to turn on the air conditioner.
NOTE: nehW the air conditioner is first plugged in,
the LED display will show “88” for 3 seconds.
After the air conditioner is turned on for the first
time, the display will show the
temperature 72 F
and
the fan is automatically set
to Low speed
and the Mode indicator will
show ENERGY SAVE.
NOTE: To switch the temperature display between
Fahrenheit (F) and Celsius(C), the air conditioner
must be plugged in, and turned ON. On the control
panel on the front of
the AC, press the UP and
DOWN button at the same time and hold for 3
seconds. The
change cannot be done using the
remote control.
3. Select Mode. Refer to “Mode.”
4. Select Speed. Refer to “Speed.”
5. Set Timer. Refer to “Temp/Time”
6. Reset the filter. Refer to “Filter Reset”
°
MODE
1. Press mode until you see the indicator light
come on next to the desired setting.
2. Choose Fan, Energy Save,Cool, or Dehum.
FAN― Only the fan runs. Press SPEED to select
High, Med or Low fan speed. The display shows
the
current room temperature.
ENERGY SAVE― In this mode the fan runs only
when cooling is
needed. The fan will run for 3
minutes after the compressor shuts off. The fan
then cycles on for 2 minutes at 10 minute intervals
until the temperature in the room is above the set
temperature. The compressor then turns back on.
FAN
DEHUM
ENERGY
SAVE
HIGH
MED
LOW
ON
OFF
MODE SPEED TIMER
°F/°C
Hr
TEMP/TIME
CLEAN
POWER
FILTER
RESET
FILTER
ON/OFF
COOL
COOL― Cools the room. Press SPEED to select
High, Med , Low Fan speed. Press the TEMP/TIME
up or down arrow button to adjust the temperature.
Loading ...
Loading ...
Loading ...