Loading ...
Loading ...
Loading ...
7
To set the timer, use the adjustment buttons + and - (B),
then wait a few seconds for the setting to be memorised.
The current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance goes
o automatically. To go back to operation without the timer,
press the timer button (E) twice.
The timer symbol disappears from the display.
Using the remote control
The functions on the remote control are the same as those on
the appliance control panel. For a description of the functions,
see the “Operation and use” section on the previous page.
Inserting or replacing the batteries
The remote control is powered
by a CR2032 lithium battery.
To operate the remote control,
pull and remove the plastic
strip under the battery cover.
To replace the batteries, remove
the battery cover by sliding it as
shown in the gure.
When replacing the batteries,
make sure you respect the
polarity (see gure 2). Replace the cover as shown in the
gure. Old batteries are harmful to the environment and
must be removed and disposed of in compliance with current
legislation.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- To clean the lter, remove the rear grille by pulling it
outwards (g. 1). Remove the dust lter which retains
impurities in the air drawn in from the room, blow on it
lightly then replace in the appliance.
- Never use abrasive powders or solvents to clean the
appliance.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “
Max Power 2400W
PROBLEM CAUSE SOLUTION
PF display and emits a beep
Temperature sensor is not working
properly
The product needs to be serviced
Customer Experience
Product doesn’t turn on Check that the plug is connected to the
outlet
Auto-start is on
Room temperature has reached the set
temperature
Plug in
Wait till time elapsed or press the but-
ton (E) twice to cancel the auto-start
and push the button (A)
Use the “+” button to increase the set
temperature
The appliance goes o unexpectedly Check that the plug is connected to the
outlet
The set temperature has been reached
or the time set on the timer has elapsed
Plug in
A green dot is ashing and unit is o The tip-over switch has been activated Make sure the appliance is standing
upright on a at surface, if the problem
persists contact our toll free number to
assist you
TROUBLESHOOTING