Loading ...
Loading ...
Loading ...
11. Using an oil filter wrench (available from your POLARIS dealer), turn the filter
counter-clockwise to remove it.
Oil Filter Wrench
PU-50105
12. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
13. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to
make sure the o-ring is in good condition.
14. Install the new filter and rotate it clockwise by hand until the filter gasket
contacts the sealing surface, then turn it an additional 3/4 turn.
15. Remove the engine access panel on the right side of the vehicle.
16. Remove the dipstick. Add the Polaris recommended lubricant as necessary
to bring the oil level within the SAFE range on the dipstick. DO NOT overfill.
FLUID CAPACITY
Recommended Lubricant:
Polaris PS-4 Synthetic 4-Cycle Engine Oil
Capacity:
2 qt (1.9 L)
17. Reinstall the dipstick.
18. Start the engine. Allow it to idle for one to two minutes.
19. Stop the engine and check for leaks.
20. Check the oil level. Add engine oil as needed to bring the level to the upper
mark on the dipstick. See Oil Check section for proper procedure.
21. Dispose of used filter and oil properly.
120
MAINTENANCE
Loading ...
Loading ...
Loading ...