Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
¾ BEFORE USING YOUR ICE MAKER
• REMOVE
THE EXTERIOR AND INTERIOR PACKAGING MATERIAL.
• CHECK
TO BE SURE YOU HAVE ALL OF THE FOLLOWING PARTS:
• 1
ICE BUCKET
• 1
PLASTIC SCOOP
• 25
FT. HOSE
• 1
INSTRUCTION MANUAL
• BEFORE
CONNECTING THE ICE MAKER TO THE POWER SOURCE, LET IT STAND UPRIGHT
FOR APPROXIMATELY 4 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A MALFUNCTION
IN THE COOLING SYSTEM FROM HANDLING DURING TRANSPORTATION.
• CLEAN
THE INTERIOR SURFACE WITH LUKEWARM WATER USING A SOFT CLOTH.
¾ INSTALLATION OF YOUR ICE MAKER
• THIS APPLIANCE IS DESIGNED TO BE RECESSED OR BUILT-IN (FULLY RECESSED).
• PLACE
YOUR ICE MAKER ON A HARD AND LEVEL FLOOR THAT IS STRONG ENOUGH TO
SUPPORT THE ICE MAKER WHEN IT IS FULLY LOADED. REMEMBER THAT THE UNIT WILL
BE SIGNIFICANTLY HEAVIER ONCE IT IS FULLY LOADED. TO LEVEL YOUR ICE MAKER,
ADJUST THE LEG AT THE FRONT OF THE ICE MAKER.
• PLACE
THE ICE MAKER AWAY FROM DIRECT SUNLIGHT AND SOURCES OF HEAT (STOVE,
HEATER, RADIATOR, ETC.). DIRECT SUNLIGHT MAY AFFECT THE ACRYLIC COATING AND
HEAT SOURCES MAY INCREASE ELECTRICAL CONSUMPTION. EXTREME COLD AMBIENT
TEMPERATURES MAY ALSO CAUSE THE ICE MAKER NOT TO PERFORM PROPERLY.
• AVOID
LOCATING THE ICE MAKER IN DAMP AND HUMID AREAS. TOO MUCH HUMIDITY IN
THE AIR WILL CAUSE FROST TO FORM QUICKLY ON THE EVAPORATOR REQUIRING MORE
FREQUENT DEFROSTING OF THE ICE MAKER.
• PLUG
THE ICE MAKER INTO AN EXCLUSIVE PROPERLY INSTALLED-GROUNDED WALL
OUTLET. DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD. ANY QUESTIONS CONCERNING POWER AND OR
GROUNDING SHOULD BE DIRECTED TOWARD A QUALIFIED ELECTRICIAN.
¾ ELECTRICAL CONNECTION
• THIS ICE MAKER SHOULD BE PROPERLY GROUNDED FOR YOUR SAFETY. THE POWER
CORD OF THIS ICE MAKER IS EQUIPPED WITH A THREE-PRONG PLUG WHICH IS USED
WITH STANDARD THREE PRONG WALL OUTLETS TO MINIMIZE THE POSSIBILITY OF
ELECTRICAL MALFUNCTION.
• DO
NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD GROUND PRONG
FROM THE POWER CORD SUPPLIED.
• DO
NOT USE AN EXTENSION CORD TO CONNECT POWER TO THE UNIT.
• NEVER
USE A TWO-PRONG GROUNDING ADAPTER.
• WHERE
A TWO-PRONG WALL RECEPTACLE IS ENCOUNTERED, CONTACT A QUALIFIED
ELECTRICIAN TO HAVE IT REPLACED WITH A 3-PRONG RECEPTACLE IN ACCORDANCE
WITH APPLICABLE ELECTRICAL CODES.
• THIS
ICE MAKER REQUIRES A STANDARD 115/120 VOLTS A.C.~/60HZ ELECTRICAL OUTLET
WITH THREE-PRONG GROUND.
• THE
CORD SHOULD BE SECURED BEHIND THE ICE MAKER AND NOT LEFT EXPOSED OR
DANGLING TO PREVENT ACCIDENTAL INJURY.
aWARNINGa
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL
SHOCK. IF THE POWER CORD IS DAMAGED, DO NOT ATTEMPT ANY REPAIRS. ORDER A
REPLACEMENT FROM YOUR WHYNTER RETAILER AND HAVE A QUALIFIED ELECTRICIAN
REPLACE THE POWER CORD
Loading ...
Loading ...
Loading ...