Loading ...
Loading ...
Loading ...
3.
4.
Remove two screws attaching access panel and lower
panel to dishwasher using a 1/4" hex socket, nut driver
or Phillips screwdriver.
Remove panels and set panels aside on a protective
surface.
Check that grounding clip is attached to the lower
panel.
lower
panel
clip
ApplyTeflon _:tape or pipe
joint compound to 90 ° elbow
fitting and connect fitting to
water inlet valve.
water inlet valve
I
Tighten elbow until snug, and
be sure that it faces to the
rear.
7. Remove terminal box cover.
- If you are direct wiring: install a UL listed/CSA
certified clamp connector to the terminal box. If using
conduit, use a UL listed/CSA certified conduit
connector.
- If you are installing a power supply cord kit, do so
now, following kit instructions.
_, _J_ [;erxm_naler
;bo,,eeC,t ,7
/
dishwasher wires
HelpfulTip: Put cardboard under dishwasher until it is
installed in cabinet opening.The cardboard will help
protect floor covering during installation.
Measure height of cabinet opening
from underside of countertop to
floor where dishwasher will be
installed (you need the lowest
point). Check chart for that height
opening. Put wheels in the required
position.
wheel
Minimum
cutout height
34" (86.4 cm)
34-1/4" (87 cm)
34-1/2" (8_6 cm)
Wheel
position
1
2
3
Number of
turns on
front leg
10
5
0
Turn both front leveler legs to the same
height.
If the minimum cutout height is less than
34" (86.4 cm), the rear wheels can be
removed for additional clearance.This will
allow the dishwasher to fit into a 33-7/8"
(86 cm) high cutout, but the dishwasher
will be more difficult to move into
front leg
position. If the wheels are removed, protect the floor
when moving the dishwasher.
if you have built-up
floors
2.
3.
Measure height of opening
from underside of
countertop to built-up
floor. If the height is at
least 33-3/4" (85.7 cm), the
shim
_/
dishwasher will fit into the
opening without
modification to the
countertop or flooring.
Put wheels in position 1
/countertop
33-3/4"
(85.7 cm)
min.
and turn the front leveler legs up all the way.
Add shims as needed in the area shown to bring
dishwasher up to proper height.
NOTE: Shims must be securely attached to floor to
prevent their movement when the dishwasher is
operated.
shim
(7.0cm)
2"
(5.1 cm)
6"
(15.2cm)
(ZOcm)
Install custom door panel kit (onsome models)
If installing a custom door panel kit, install it now following
instructions included with kit.
10
Loading ...
Loading ...
Loading ...