Quick Start Guide
Setting Up and Using Your High-Eciency
Top Load Washer
CONNECT INLET HOSES
TO FAUCETS
1
CONNECT INLET
HOSES TO WASHER &
CHECK FOR LEAKS
3
Do not overtighten or use tape or
sealants when attaching to faucets.
Make sure that both hot
and cold water hoses are
connected to the correct
faucets. The washer will
not operate unless both
hoses are connected.
IMPORTANT:
Make sure that water faucets are turned on fully before using the washer
for the rst time.
If there is no/low water pressure
to the washer, the cycle status
lights will appear as shown at
right. To clear, open and close
the lid.
4
CHANGING COIN SLIDE PRICING
Refer to
W10631033
Coin Slide
Installation
Instructions
for detailed
instructions
located in the coin box.
*Applies only to select models.
CLEAR
WATER LINES
2
Do not
overtighten
or use tape
or sealants
when attaching
to washer.
KEYS, COIN SLIDE, AND COIN BOX*
FREE FAX
800-ESD-KEYS
012124
DO NOT
DUPLICATE
LOCATION OF KEYS
Coin box key (shown) comes
taped to coin box lock.
Service door key is locked
inside coin box.
Document the key code
(engraved on coin box key)
in a safe place.
If key is lost, contact 1-800-523-1510
for replacement (not covered by warranty).
Have key code handy; otherwise, locksmith
will have to drill out coin box and replacement coin
box (part no. 4396671) will have to be installed.
*Applies only to select models.
W10762279B
W10762284B - SP
CONNECTING WATER
Make sure that the washer is level (see the “Level Washer” section in the Installation Instructions). Run
a wash cycle to verify that the washer is working correctly and has no leaks at faucets and inlet hoses.
Insert new hose washers (in
separate bag) into each end of inlet hoses.
Firmly seat washers into couplings.
Turn on
faucets and
check for
leaks at both ends of hoses.
Loading ...
Loading ...
Loading ...
