Loading ...
Loading ...
Loading ...
ENG
ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or recycled.
Ü
Take it to a local civic waste collection point.
If you have any problem or queries,
please contact our Customer Relations team first for expert help and advice.
Problem Possible causes Solutions
Water drips from the holes in the
soleplate.
Brown streaks come through the
holes in the soleplate and stain
the linen.
The soleplate is dirty or brown
and can stain the linen.
There is little or no steam.
The soleplate is scratched or
damaged.
Water is running out of the tank
filler hole.
Steam comes from the iron as
you finish filling the tank.
The spray does not spray
The chosen temperature is too low
and does not allow for the formation
of steam.
You are using steam while the iron is
not hot enough.
You are using the Shot of Steam
button too often.
The steam flow is too high.
You have stored the iron horizontally,
without emptying it and without
setting it to DRY.
You are using chemical descaling
agents.
You are using pure distilled/deminera-
lised or softened water.
Fabric fibres have accumulated in the
holes of the soleplate and are burning.
Your linen has not been rinsed sufficiently
or you have ironed a new garment before
washing it.
You are using too high a temperature.
Your linen has not been rinsed
sufficiently or you have ironed a new
garment before washing it.
The water tank is empty.
The anti-calc valve is dirty.
Your iron has a build-up of scale.
You iron has been used dry for too long.
You have placed your iron flat on a
metallic rest-plate.
You have not closed the tank stopper
properly.
The steam control is not set to the
DRY position.
The tank is empty.
Set the thermostat in the coloured
zone (from ●● to MAX).
Wait until the thermostat light goes
out.
Wait a few seconds between each use
of the button.
Reduce the steam flow.
See the section "Storing your iron".
Do not add any descaling agents to
the water in the water tank.
(see section “what water to use).
Carry out a self-clean and use untreated
tap-water.
Carry out a self-clean.
Clean the soleplate with a non-metallic
sponge.
Vacuum the holes of the soleplate
from time to time.
Clean the soleplate as indicated above.
See the temperature table to correctly
set the thermostat.
• Clean the soleplate as indicated above.
Always spray starch onto the reverse
side of the fabric to be ironed.
Fill it.
Clean the anti-calc valve.
Clean the anti-calc valve and carry out
a self-clean.
Carry out a self-clean.
Always set your iron on its heel.
Make sure that the stopper is properly
closed and that the arrow points to
the “closed padlock” symbol.
Check that the steam control is set to
the DRY position.
Fill the tank.
5-IF THERE IS A PROBLEM
Loading ...
Loading ...
Loading ...