Loading ...
Loading ...
Loading ...
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
About cycle options.
NOTE: Not all features are available on all dryer models. GEAppliances.com
Extend Tumble
Minimizes wrinkles by adding approximately
60 minutes of no-heat tumbling after clothes
are dry. The beeper will sound every
2 minutes to remind you to remove
the clothes. The ESTIMATED TIME REMAINING
display will show 00.
Damp Alert (on some models)
This option causes the dryer to beep when
clothes have dried to a damp level. Remove
items that you wish to hang dry. The DAMP
ALERT will only beep when this option is
selected.
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.
Signal
Alerts you that the cycle is complete.
The beeper will continue to sound every
two minutes for the next 6 minutes, until
the clothes have been removed. The clothes
should be removed when the beeper goes
off so wrinkles donโt set in.
Press SIGNAL to select low, medium or high
volume, or to turn the beeper off.
Delay Start (on some models)
Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press DELAY START. You can change
the delay time in 1 hour increments using
the + or โ arrow pads.
3. Press the START pad to start
the countdown.
The countdown time will be shown in
the ESTIMATED TIME REMAINING display.
NOTES:
๎ If the door is opened while the dryer is
in DELAY, the countdown time will not
restart unless the door is closed and
START has been pressed again.
๎ You can delay the start of a dry cycle
up to 18 hours for models DCVH640,
DCVH680, DHDVH68 and up to 10 hours
for model DBVH520.
D
AMP
A
LERT
E
XTEND
T
UMBLE
10
Loading ...
Loading ...
Loading ...