Loading ...
Loading ...
Loading ...
6
Cycle Status Lights
Delay
If a Delay Start is set, the Delay indicator will light
and the delay time will count down in the display.
Door Locked
Door Locked will light to indicate that the door
is locked and cannot be opened without first
pausing or canceling the cycle.
Sensing
When START is touched and held, the washer
will first perform a self-test on the door lock
mechanism and the sensing light will come on.
You will hear a click, the drum will make a partial
turn,
and the door will unlock briefly before locking again.
Once the door has locked the second time, the washer will begin
tumbling and adding water. This sensing process will continue
throughout the cycle. You may also hear water flowing through
the dispenser, adding detergent to the load.
After the load size is sensed, the estimated time based on load
size will be displayed. The actual cycle time may be lengthened;
however, the display will continue to show the estimated time.
The sensing light will blink once a second at various times during
the cycle, such as when the washer is reducing extra suds.
Add a Garment
When “Add a Garment” is lit, you may pause the washer,
open the door, and add items.
Steaming
This will light to show that the cycle is using a steam boost
for added cleaning power.
Done
Once the cycle is complete, this light will come on. Remove the
load promptly for best results.
The Done indicator is also lit during
Fresh Hold
®
or Fresh Spin
™
option.
CONTROL PANEL AND FEATURES
Adding HE detergent to dispenser
Powdered detergent:
Lift the selector to the high
position.
Liquid detergent:
Push down the selector to the
low position.
Pour a measured amount of HE
detergent into detergent compartment.
For powdered detergent, lift the selector
to the high position. For liquid detergent,
push down the selector to the low
position.
Use only High Efficiency
(HE) detergent.
Do not overfill; adding too much detergent may cause
detergent to be dispensed into the washer too early.
IMPORTANT:
n Do not add single-dose laundry packet to dispenser drawer.
n Use powdered detergent when using the Delay Start option.
Liquid detergent may seep out before the wash begins.
HE detergent
compartment
USING THE DISPENSER DRAWER
1. Open the dispenser drawer.
2. Add laundry products as described in steps 4–6 in the
“Using Your Washer” section.
3. Slowly close the dispenser drawer. Make sure it is
completely closed.
NOTE: A small amount of water may remain in the dispensers from
the previous wash cycle. This is normal.
Selector
Selector
in high
position
Selector
in low
position
Loading ...
Loading ...
Loading ...