User Manual - Page 11

For HL10CESWW. Series: HL10 Series, HL12 Series, HL14 Series
Also, The document are for others Honeywell models: HL10CESWK, HL10CESWG, HL10CESWB, HL12CESWW, HL12CESWK, HL12CESWG, HL12CESWB, HL14CESWW, HL14CESWK, HL14CESWG, HL14CESWB, HL14CHESWW, HL14CHESWK, HL14CHESWG, HL14CHESWB

Loading ...
Loading ...
Loading ...
TROUBLESHOOTING GUIDE
The following troubleshooting guide addresses the most common problems. If problems persist, call
customer service. Unplug and disconnect the appliance from the power source before attempting to
troubleshoot.
The air conditioning
unit does not start
Runs only a short
while
No electricity.
Batteries in the remote control need
to be replaced.
The power cord is not properly
plugged in.
The safety LCDI plug has tripped
(USA / Canada / Mexico only).
The thermostat temperature setting
is too close to the room tempera-
ture.
Air outlet is blocked.
There are tight bends in the air
exhaust hose.
Check for power.
Change remote control batteries.
Remove and reconnect the
power cord.
Reset the safety LCDI plug, if
problem persists contact our
customer support (USA /
Canada / Mexico only).
Lower the set temperature.
Make sure the exhaust hose is
properly connected.
Connect exhaust hose as per
instructions on page 4.
Runs but not cooling A door or window is open.
The air filter is dirty.
The exhaust hose is detached.
Temperature setting is too high.
Air outlet or intake is blocked.
Room exceeds recommended size.
Large size or number of windows
are decreasing cooling effectiveness.
Make sure the window or door
is closed.
Clean the air filter.
Reinstall exhaust hose properly
(refer to Installation section).
Reduce temperature setting.
Remove blockage.
Move unit to smaller room.
Cover windows with curtains or
blinds.
PROBLEM POSSIBLE CAUSE SOLUTION
EN 10
Excess water condensation inside
the tank.
Drain the water (refer to Water
Condensation Drainage).
Will not run and
WATER FULL indicator
is on
Heater* is not
switching ON
(This applies to
Portable Air
Conditioner models
with built-in Heating*
function only).
Heating* function not activated yet.
Temperature setting is too low.
Check that the Heating* function
has been activated. Increase
temperature setting.
*Applicable for models with Heating feature only.
Loading ...