Loading ...
Loading ...
Loading ...
en-us
6
Scope of Delivery
After unpacking all parts, check for any damage
in transit.
If you have any complaints, please contact the dealer
from whom you purchased the appliance or our
Customer Service department.
The following parts are included:
■ Built-in appliance
■ Interior fittings (depending on model)
■ Bag containing installation materials
■ Operating Instructions
■ Installation Instructions
■ Customer Service Booklet
■ Warranty enclosure
■ Information on the energy consumption and noises.
Connecting the Appliance
Have a technician install and connect the appliance
according to the enclosed Installation Instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until
the appliance has been installed.
Apart from statutory national regulations, you should
comply with all applicable local electricity companies
codes and requirements.
After installing the appliance, wait at least 1 hour before
switching the appliance On. During transportation
the oil in the compressor may have flowed into
the refrigeration system.
Before switching the appliance On for the first time,
clean the interior of the appliance (see chapter
“Cleaning the Appliance”).
Electrical Connection
, WARNING:
RISK OF ELECTRIC SHOCK
Connect the appliance to a grounded, 3-phase
outlet only. Never remove the ground phase. Do
not use any adapters.Do not use any extension
leads.
, WARNING:
RISK OF ELECTRIC SHOCK
Incorrect connection of the appliance may result
in death, fire or electric shock. Improper
connection of the protective conductor may
result in electric shock. If you are in doubt as to
whether the appliance has been properly
grounded, have it tested by a qualified electrician
or Customer Service technician.
, WARNING:
RISK OF ELECTRIC SHOCK
If the length of the power cord is inadequate,
never use multiple outlets or extension leads.
Instead, please contact Customer Service for
alternatives.
This appliance must be connected to a permanently
installed outlet.
The outlet must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with protection class I. Connect
it to a correctly installed outlet. Correct means: with a
protective conductor, 110 V – 120 V/60 Hz alternating
current. The outlet must be protected by a 10 A – 16 A
fuse.
The appliance comes with a UL registered 3-wire power
cord. The appliance requires a 3-pole outlet.
Please observe the following table with regard to this.
Check on the rating plate whether the indicated voltage
and current type match the values of your power
supply.
The position of the rating plate can be found in the
chapter entitled Customer Service.
, WARNING:
Never connect the appliance to electronic energy
saver plugs.
Our appliances can be used with mains and sine
controlled inverters. Mains-controlled inverters
are used for photovoltaic systems which are
connected directly to the national grid. Sine
controlled inverters must be used for isolated
applications (e.g. on ships or in mountain
lodges) which are not connected directly to the
national grid.
Appliance Maximum Simultaneous Load
Refrigerator 30“ 2.0 amps
Loading ...
Loading ...
Loading ...