User Manual - Page 50

For 2014 428I CONVERTIBLE.

Loading ...
Loading ...
Loading ...
Closing without the pinch protection
system
Keep the closing path clear
Monitor closing and make sure that the
closing path of the window is clear; otherwise,
injuries may result.◀
E.g. danger from the outside or ice might pre‐
vent window from closing properly - proceed
as follows:
1. Pull the reel past the resistance point and
hold it there.
The pinch protection is limited and the
window reopens slightly if the closing force
exceeds a certain margin.
2. Pull the reel past the resistance point again
within approx. 4 seconds and hold it there.
The window closes without jam protection.
Hardtop
General information
The hardtop can be opened and closed at
walking speed.
If the vehicle is accelerated while the hardtop is
in motion, the movement is stopped.
Hints
If the hardtop is not completely opened or
closed, the trunk lid cannot be opened
since it would bump against the hardtop.
If possible, close the hardtop when the ve‐
hicle is parked. A closed hardtop protects
car from weather-related damage and
against theft.
It is not possible to start the engine and
operate the hardtop simultaneously. When
the engine is started using the Start/Stop
button or using the Auto Start/Stop func‐
tion, the hardtop movement is briefly inter‐
rupted.
At a glance
Hardtop buttons
Functional requirements
The ignition or radio-ready state must be
switched on.
The following requirements must be fulfilled in
order to be able to move the hardtop.
The cargo area partition is flipped down.
The loading aid, refer to page 159, is shut
down.
The trunk lid is closed.
The external temperature is above
14 ℉/-10 ℃.
The voltage of the vehicle electrical system
is sufficient.
The hardtop drive is not overheating.
The vehicle speed is not too high.
The lateral tilt of the vehicle is not too
great.
The windows can be lowered.
If this requirement is not met, a check control
message is displayed.
Safety information
Note the swivel range of the hardtop
The hardtop pivots back and up during
opening and closing. When the hardtop is
moved, e.g., in garages, make sure that the
space at the top is at least 79 inches/2 meters
and the space at the rear is at least 20 in‐
Seite 46
Controls Opening and closing
46
Online Edition for Part no. 01 40 2 956 860 - X/14
Loading ...
Loading ...
Loading ...