Loading ...
Loading ...
Loading ...
4
Installation of new washer/dryer
If your washer/dryer is still in the packaging:
Cut packaging as follows:
Washer: Cut plastic lm along dotted cut line around the
base. Do not remove the packaging. Locate the transport
bolts on rear of washer. Transport bolts must remain in washer
while pedestal is installed. When laying the washer on its back,
hold the bottom cap down on the oor. Do not remove the
plastic lm, corner posts, or top cap.
Dryer: Cut carton around top and down corners along dotted
cut lines. Lay all four carton sides on oor. Discard carton top
and corner posts.
Washer/Dryer still in packaging
Washer
Dryer
Conrm transport bolts are in place
NOTE: Transport bolts are only in washers.
Loading ...
Loading ...
Loading ...