Loading ...
Loading ...
Loading ...
Setting Surface Controls
Single Radiant Surface Elements (all models)
To Operate a Single Radiant Element:
1. Place correctly sized cookware on the radiant surface element.
2. Push in and turn the surface control knob in either direction to the
desired setting (See Fig. 1). Start most cooking operations on a
higher setting and then turn to a lower setting to finish cooking. The
surface control knobs do not have to be set exactly on a particular
mark. Use the marks as a guide and adjust the control knob as
needed. Each surface element provides a constant amount of heat at
each setting. A glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware istoo small for
the surface heating area.
3. When cooking is complete, turn the surface element OFF before removing the cookware. Note: The ELEMENT ON
indicator light will glow when one or more elements are turned ON. A quick glance at this indicator light when cooking
isfinished isan easy check to be sure all control knobs are turned OFF. The Hot Surface indicator light will continue
to glow AFTER the control knob is turned to the "OFF" position and will glow until the heating surface area has cooled
sufficiently.
Simmer Select Surface Element (some models)
The left front element control may be used as a normal element or as a simmer element. The "Simmer Select" feature heats
the element at a much lower temperature than when used as a normal surface element. You may switch between normal
cooking and the Simmer Select feature at any time during the cooking process. When using the element control for normal
cooking all of the settings on the control knob (LO to HI) function as normal.
To Start Simmer Select:
1. Place correctly sized cookware on the radiant surface element.
2. Push in the Simmer button located below the left front control knob.
3. Turn the surface control knob to the desired simmer setting within the dark band on the control knob (LO to 4). Use the
marks as a guide and adjust the control knob from LO to 4 as needed (see illustration below).The Simmer Select
indicator light will glow and remain ON while simmering (See Fig. 2).
4. To return to normal cooking, push in and release the "Simmer Select" button and the indicator light will turn OFF. When
cooking is complete, be sure to set the control knob to the OFF position.
Simmer Select Surface Control
shown in LO setting
...................................................................................................................................................................................Max. Simmer (4)
Fig. 2
Min. Simmer (LO)
The suggested settings found in the table below are based on cooking in medium-weight
aluminum pans with lids, Settings may vary when using other types of pans,
RECOMMENDED SETTINGS FOR SURFACE ELEMENTS
Setting Type of Cooking
HIGH (HI - 9) Start most foods, bring water to a boil, pan broiling
MEDIUM HIGH (7 - 8) Continue a rapid boil, fry, deep fat fry
MEDIUM (5-6) Maintain a slow boil, thicken sauces and gravies, steam vegetables
MEDIUM LOW (2- 4) Keep foods cooking, poach, stew
LOW (LO - 1) Keep warm, melt, simmer
SIMMERSELECTSURFACE ELEMENT
Larger quantities of food, stews and soups
Smaller quanitites of food, delicate foods, melting chocolate or butter
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch
fire if placed too close to the surface elements.
Do not allow aluminum foil, empty glass/porcelain cookware or ANY material that can melt to
make contact with the ceramic cooktop. If these items melt on the cooktop they WILL damage the ceramic cooktop.
Loading ...
Loading ...
Loading ...