Loading ...
Loading ...
Loading ...
- 7 -
The unit has an optional continuous drainage port. Water can be continually drained by connecting a rubber
hose (15mm I.D), to this drainage port.When setting up the dehumidifier for continuous drainage, always
turn the unit off and unplug the supply plug.
2. Push the hose into the continuous drainage port
Pass a rubber hose (15mm I.D) through the continuous
drainage port, and press it firmly into the drainage port in
the main unit, making sure water does not leak.
The height of drain piping should always be lower than the
height of the drainage port.
Make sure there are no kinks or obstructions in the rubber
hose which may prevent the water draining out.
3.Return the drainage tank to its original position
Check the hose periodically to make sure it is still connected
and has not been obstructed.
1. Disconnect the drainage tank and open the
continuous drainage port.
Use sidecutters or similar tool to cut away the continuous
drainage port in the side of the main unit.
Operation
Draining the water
Continuous drainage of water
1.Drain the water.
2.Lift up the handle.
3.Move the unit.
1.If the floor is made of a material that scratches easily, or if the floor is uneven, lift up the unit and move
it. Also avoid rolling the unit on castors if the floor has shagpile carpet.
2.Tilt it within range of 20 to 30 degrees, as a rule (if you tip it too far, you may scratch the floor or water
may leak.)
3.Be careful that the power supply cord doesn't get pinched under the unit.
Moving the dehumidifier (using castors)
Note:
At least 50 cm
At least 20 cm
At least 20 cm
At least 20 cm
At least 20 cm
Ensure the dehumidifier has adequate clearance
between the unit and nearby walls as shown
below.
Loading ...
Loading ...
Loading ...