Loading ...
Loading ...
Loading ...
2.41
ACTIVE EMERGENCY BRAKING (3/10)
System A (continued)
Operating faults
When the system detects an operating
fault, the
warning light lights up
on the instrument panel, with the mes-
sage “Active braking disconnected”.
There are two possibilities:
– the system is temporarily disrupted
(for example: radar obscured by
dirt, mud, snow etc.). In this case,
park the vehicle and switch off the
engine. Clean the detection zone of
the radar. When you next start the
engine, the warning light and the
message go out
– if this is not the case, this may arise
from another cause; contact an
Approved Dealer.
Consult an approved dealer.
Active emergency braking
This function is an additional driving aid. This function is not under any
circumstances intended to replace the due care and attention of the
driver, who should at all times be in control of the vehicle. The triggering
of this function may be delayed or prevented when the system detects clear signs
of control of the vehicle by the driver (action on the steer-ing wheel, pedals etc.).
System servicing/repairs
– In the event of an impact, the radar-camera or radar alignment may be changed,
and its operation may consequently be affected. Deactivate the function, then
consult an authorised dealer.
– Any work in the area where the radar-camera or radar are located (repairs, re-
placements, windscreen modifications etc.) must be carried out by a qualified
professional.
– Fitting accessories which may block the radar is prohibited (bull bars etc.).
Only an authorised dealer is qualified to service the system.
In the event of system disturbance
Some conditions can disturb or damage the operation of the system, such as:
– a complex environment (metal bridge, tunnel etc.);
– poor weather conditions (snow, hail, black ice etc.);
Risk of inadvertent braking.
Loading ...
Loading ...
Loading ...