Loading ...
Loading ...
Loading ...
17
Change of door opening direction
Should the setting-up place or handling demand it,
door-opening direction can be refitted from right-
handed to left-handed.
Appliances on the market are right-handed.
Following operations are to be done on the basis of
figures and explanations:
To perform the operations listed below it is
recommended to ask another person for help who
safely can keep the doors while performing the
operations.
Disconnect the appliance from the electricity
supply.
Open the doors and dismount the double door
hinge (a,b) by removing the screws (2 pieces) (c).
(fig.2)
Take off the double door hinge (a,b,c) by gradually
removing it from the cabinet, slightly tilting both
doors. Do not forget to remove the plastic spacer
(b) under the hinge. (fig.2)
Take off the refrigerator door by pulling it slightly
downwards.
Take of the freezer door by pulling it slightly
upwards.
Remove the plug on the upper side of the
refrigerator door and put it to the other side.
Remove the plug on the upper side of the freezer
door and put it to the other side.
Unscrew the top door hinge pin (d) of the
refrigerator then screw it back on the other side.
(fig.1)
Remove the insert of the plinth (e) by a screwdriver.
(fig.3)
Unmount the lower hinge pin (f) and its washer (h)
and mount them on the other side. (fig.3)
Replace the insert of the plinth (e) on the other
side.
Remove the covering nails (3 pieces) (n,k) of the
double door holder on the left side and put them to
the other side. (fig.2)
Fit the pin of the double door hinge (m) into the left
drill of the freezer door. (fig.2)
Fit the freezer door to the lower door hinge pin (f).
(fig.3)
Fit the refrigerator door to the upper door hinge pin
(d) then slightly tilting both doors fit the pin of the
double door hinge (m) into the left drill of the
refrigerator door.
Opening both doors fix the double door hinge onto
the left side using the screws (2 pieces) (c). Do not
forget to replace the plastic spacer (b) under the
hinge. Be careful that the door edges are parallel
with the edge of the mantle.
Put over the handles (r) on the other side and put
the plastic covering nails (p) supplied in the plastic
bag of this instruction book into the holes set free.
(fig.4)
Put the appliance to its place, set it level, and apply
to voltage it.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
fig. 1.
fig. 2.
fig. 3.
fig. 4.
Loading ...
Loading ...
Loading ...