Loading ...
Loading ...
Loading ...
Automatic safety cut-out en
9
When the time has elapsed
When the cooking time has elapsed, the hotplate
switches off. You will hear an audible signal and
‹‹
lights up in the display for 10 seconds. The x display
lights up brightly. Touch any symbol. The displays go
out and the audible signal ceases.
Changing or cancelling the cooking time
Select the hotplate and touch the 0 symbol. The x
display lights up brightly. Change the cooking time or
set to ‹‹ in the settings range.
Note: You can set a cooking time of up to 99 minutes.
Automatic timer
You can use this function to preselect a cooking time
for all hotplates. Each time a hotplate is switched on,
the pre-selected cooking time then counts down. When
the cooking time has elapsed, the hotplate switches off
automatically.
You can find out how to switch on the automatic timer in
the Basic settings section.~ Page 10
Note: You can change the cooking time for a hotplate
or switch off the automatic timer for the hotplates.
Select the hotplate and touch the 0 symbol. The
desired x display lights up brightly. Change the
cooking time or set to ‹‹ in the settings range.
Kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes. It runs independently of all the other settings.
Switching on the kitchen timer
You can switch the kitchen timer on in 2 different ways:
■ If a hotplate has been selected, touch the 0 symbol
twice within 10 seconds.
■ If a hotplate has not been selected, touch the 0
symbol.
The V display lights up.
Setting the kitchen timer
Set the desired time in the control panel.
After the time has elapsed
After the time has elapsed, you will hear a beep. ‹‹
lights up in the timer display. The V display for the
kitchen timer lights up brightly. The display switches off
after 10 seconds.
Displaying the time
Use the 0 symbol to select the kitchen timer. The time
is displayed for 10 seconds.
Setting the correct time
Use the 0 symbol to select the kitchen timer and reset
the time.
bAutomatic safety cut-out
Au t o mat i c saf et y cut - out
If a hotplate has been switched on for a long time
without the setting being changed, the automatic time
limit is activated.
The hotplate stops heating. ”‰ and the •/œ residual
heat indicator flash alternately on the hotplate display.
The display goes out when you touch any control. You
can make new settings.
When the time limit is activated depends on the heat
setting selected (1 to 10 hours).
kWipe protection
Wipe pr ot ect i on
If you wipe over the control panel while the hob is
switched on, settings may be changed.
To prevent this from happening, your hob has a wipe
protection function. Touch the > D symbol. A beep
goes off and the display light above the > D symbol
lights up. The control panel is locked for 30 seconds.
You can now wipe over the control panel without
changing any settings.
Note: The primary switch is not affected by the wipe
protection function. You can switch off the hob at any
time.
[Energy consumption
indicator
En e r gy c onsumpt i on indicator
You can use this function to display the total energy
consumption between switching the hob on and off.
Once switched off, the energy consumption is displayed
in kilowatt hours (e.g. 1.08 kWh) for 10 seconds
The accuracy on the display depends on the voltage
quality of the power supply, among other factors.
The display has not been activated. You can find out
how to activate the display in the Basic settings
section.~ Page 10
Loading ...
Loading ...
Loading ...