Loading ...
Loading ...
Loading ...
Operation
●
Time.
●
Navigation instructions.
●
Outside temperature.
●
Compass.
●
Shift lever position ››› page 133.
●
Recommended gear (manual gearbox)
››› page 74
.
●
M
u
ltifunction display (MFD) and menus
with different setting options ››› page 72.
●
Service interval display ››› page 80.
●
Second speed display ››› page 72.
●
Speed warning function ››› page 79.
●
Start-Stop system status display
››› page 148.
●
Low consumption driving status (ECO)
››› page 69
●
Identifying letters on engine (MKB).
●
Active cylinder management display
(ACT
®
)* ››› page 142
Mileage
The odometer registers the total distance
travelled by the car.
The odometer (trip) shows the distance trav-
elled since the last odometer reset. The last
digit of the trip recorder indicates distances
of 100 metres or one tenths of a mile.
●
Briefly press the button ››› Fig. 82
4
to re-
set the trip recorder to 0.
●
Keep the button
4
pressed for about 3
seconds and the previous value will be dis-
played.
Time
●
To set the time, keep the button ››› Fig. 82
4
pressed for more than 3 seconds to select
the hour or minute display.
●
To continue setting the time, press the up-
per or lower part of the button
4
. Hold but-
ton down to scroll through the numbers
quickly.
●
Press the button
4
again in order to finish
setting the time.
The time can also be set via the
key and
Setup
function button in the Easy Connect
system ››› page 81
.
C
omp
ass
With the ignition on and the navigation sys-
tem on, the cardinal point corresponding to
the direction of travel of the vehicle is dis-
played on the instrument panel.
Selector lever position
The selected gear is displayed on the side of
the selector lever and on the instrument pan-
el display. In positions D and S, and with the
Tiptronic, the corresponding gear is also dis-
played.
Recommended gear (manual gearbox)
The recommended gear in order to save fuel
is displayed on the instrument panel while
you are driving ››› page 74.
Second speed display (mph or km/h)
In addition to the speedometer, the speed
can also be displayed in a different unit of
measurement (in miles or in km per hour).
This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
The second speed display can be adjusted in
the Easy Connect system via the
key and
the
Setup
function button ››› page 81.
Speed warning
When the speed setting is exceeded, this will
be indicated on the instrument panel display.
This is very useful, for example when using
winter tyres that are not designed for driving
at the maximum speed of the vehicle
››› page 79
.
The s
peed w
arning settings can be adjusted
in the Easy Connect system via the
key
and the
Setup
function button ››› page 81.
Start-Stop operating display.
Updated information relating to the status is
displayed on the instrument panel
››› page 148
.
68
Loading ...
Loading ...
Loading ...