Loading ...
Loading ...
Loading ...
5
displayed. This may happen a number of times in an hour.
7. To distribute the air ow over a wider surface, press the
swing button (F) .
The appliance starts swinging to the right and left. To
stop the appliance in the desired position, simply press
the swing button (F) again.
8. To turn the appliance o, press the ON/STAND-BY
button (A). The display may visualize a countdown for
about 6 seconds.
Please note:
Room temperature can be displayed in
either °C or °F.
To change the unit of measurement for the temperature,
press the + button for a few seconds, then release.
Digital 24 h timer
This function can be activated from any operating mode.
Auto-start: with the appliance in STAND-BY, press the timer
button (E) . The symbol is displayed together with
the time remaining before the appliance comes on.
To adjust the timer, use the adjustment buttons + and - (B),
then wait a few seconds for the setting to be memorised.
The stand-by light (H) is displayed together with the
symbol, indicating that the timer has been set.
When the programmed time
is reached, the appliance comes on with the settings used
during the previous period of operation.
Auto-o: with the appliance on, press the timer button
(E). The symbol is displayed together with the time remai-
ning before the appliance goes o.
To set the timer, use the adjustment buttons + and - (B), then
wait a few seconds for the setting to be memorised.
The current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance goes o
automatically.
To go back to operation without the timer, press the timer
button (E) twice.
The timer symbol
disappears from the display.
Using the remote control
The functions on the remote control are the same as those on
the appliance control panel.
For a description of the functions, see the “Operation and use”
section on the previous page.
Inserting or replacing the batteries
The remote control is powered by a CR2032 lithium battery.
To operate the remote control, pull and remove the plastic
strip under the battery cover.
To replace the batteries, remo-
ve the battery cover by sliding
it as shown in the gure.
When replacing the batteries,
make sure you respect the po-
larity (see gure 2).
Replace the cover as shown in
the gure.
Old batteries are harmful to
the environment and must be
removed and disposed of in
compliance with current legislation.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- To clean the lter, remove the rear grille by pulling it
outwards (g. 1).
Remove the dust lter which retains impurities in the air
drawn in from the room, blow on it lightly then replace
in the appliance.
- Never use abrasive powders or solvents to clean the ap-
pliance.
TROUBLESHOOTING
If the appliance displays “PF” and emits a beep, the tempera-
ture sensor is malfunctioning.
If the problem continues, contact customer services.
If the appliance goes o unexpectedly:
- Make sure it is plugged in correctly to the mains socket.
- Make sure the appliance is standing upright on a at
surface, otherwise the tip over device may be activated.
- Check the temperature and timer settings.
The appliance may have gone o because the set tem-
perature has been reached or the time set on the timer
has elapsed.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “
Fig. 2