Loading ...
Loading ...
Loading ...
is also advisable to avoid any drastic changes in duct
cross-section
(recommended diameter: 150mm).
Fitting under wall unit
1. Before fixing the hood to the unit, drill a hole of 165mm diameter for
φ150mm exhaust Ducting or 135mm for φ120mm exhaust Ducting in
the wall unit.
2. In any case, check the position of the power outlet and consider where
the power cable will run, since a hole might have to be made in the wall
unit to accommodate it.
3. Unscrew the 2 visible screws located on hood of both the side-ends and
remove the face plate. The 8 mounting holes around the unit are then
accessible.
4. Lift the rangehood and fit through the opening of the cabinet. Secure
unit by using 8 long mounting screws. Fit the face plate on the hood by
screwing 2 screws.
5. Make the electrical connection.
Installation is now complete.
Notice:
-Exhaust air must not be discharged into a flue which is used for exhausting
fumes from appliance burning gas or other fuels.
-If the instructions for installation for the gas hob specify a greater distance
than 750mm, this has to be taken into account.
-The regulations concerning the discharge of exhaust air have to be followed.
Check with the local authority for building codes for exhaust ducting
requirements
Loading ...
Loading ...
Loading ...