Loading ...
Loading ...
Loading ...
19
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver
to help hold the gas orice spud in the nut driver while
changing it. Press nut driver down onto the gas orice spud
and remove by turning it counterclockwise and lifting out.
Set gas orice spud aside.
4. Gas orice spuds are stamped with a number on the side.
Replace the Propane gas orice spud with the correct
Natural gas orice spud.
Refer to the following chart for the correct Natural gas orice
spud placement.
Natural Gas Orice Spud Chart
Burner Rating Color Size
ID
Number
15,000/15,500 BTU
Black/White 1.94 mm N194
12,000/12,500 BTU
Red/Yellow 1.80 mm N180
9,500 BTU
Red/Brown 1.55 mm N155
8,000 BTU (round)
Red/White 1.40 mm N140
8,000 BTU (oval)
White/Yellow 1.25 mm N125
5,000 BTU
Red/Brass 1.10 mm N110
NOTE: Refer to the Model Number and Serial Number Plate
located on the oven frame behind the top left side of the oven
door for proper sizing of spuds for each burner location.
5. Place Propane gas orice spuds in plastic parts bag for
future use and keep with package containing literature.
6. Replace the burner base using both screws.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner (Propane Gas to
Natural Gas)
1. Remove the oven racks.
2. Remove 2 screws at the rear of the oven bottom.
3. Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
4. Remove 2 screws from the front tabs of the ame spreader.
Lift front of the ame spreader and pull forward to remove
tabs from rear of oven and set it aside on a covered surface.
5. Remove 2 screws from the bake burner.
6. Slide the front of the bake burner to the side to remove tab
from front of oven. Lift the back of the bake burner off the
oven orice, and set the bake burner aside.
7. Use a 3/8" (1 cm) nut driver or combination wrench and turn
the Propane gas bake burner orice spud counterclockwise
to remove. The spud will be stamped with a “57.”
B
A
C
D
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
XXX
A
A. Stamped number
A
B
A. Screws
B. Oven bottom
A
B
A. Screws
B. Flame spreader
A
B
A. Screws
B. Bake burner
Loading ...
Loading ...
Loading ...