Loading ...
Loading ...
Loading ...
18 INSTALLATION
3 Connect all the wire harnesses and the
ground screw.
NOTE
• The number of wire harnesses may vary
depending on the model.
4 Push the water supply tube into the hole on
the top case and pull it through the backplate.
5 Hold the water supply connection and gently
push in the collet d to connect the water
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
NOTE
• Disassembling/Assembling the Water Lines
e Collet f Tube g Insert line h Clip
• Gently press the collet and insert the tube until
only one line shows on the tube.
6 Set the cover i in place. Insert and tighten
the cover screw j.
Removing the Freezer Drawer
For models with two freezer drawers, remove the
second freezer drawer in the same way.
WARNING
• Use two or more people to remove and install
the refrigerator doors and freezer drawer.
• Be careful of sharp hinges on both sides of the
drawer.
Type A
Type B
us_main.book.book Page 18 Tuesday, April 21, 2020 2:27 PM
Loading ...
Loading ...
Loading ...