Loading ...
Loading ...
Loading ...
8
Level the Washer
Properly leveling your washer avoids excessive noise and
vibration.
Check the levelness of the washer by placing a level on the 1.
top edge of the washer, rst side to side, then front to back.
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, rst prop the
front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this
step until washer is level.
Make sure all four feet are stable and resting on the oor. 2.
Then check that the washer is perfectly level (use a level).
After the washer is level, use a 9/16" open-end wrench to 3.
turn the nuts on the feet tightly against the washer cabinet.
IMPORTANT: All four feet must be tightened. If the nuts
are not tight against the washer cabinet, the washer may
vibrate.
The washer should not move front to back, side to side, 4.
or diagonally when pushed on its top edges.
Slide the washer to its nal location.5.
Conrm the levelness of the washer.6.
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose.
To keep drain water from going back into the washer:
Use the drain hose form, and do not force excess drain ■
hose into standpipe. Hose should be secure, but loose
enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub. ■
Floor drain
You may need additional parts. See Floor drain under “Tools
and Parts.”
Secure the Drain Hose
Drain hose must be secured to stop the hose from moving when
water is pumped out. If the drain hose moves, water may end up
on the oor.
Drape the power cord over the washer top.1.
Move the washer to its nal location.2.
Place the drain hose in the laundry tub or standpipe as 3.
shown. See illustrations A and B.
If the washer faucets and the drain standpipe are recessed, 4.
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
4.5"
(114 mm)
A B C
NOTES:
Do not force excess drain hose back into the rear of the ■
washer.
To avoid siphoning, do not seal or put more than 4½" ■
(114 mm) of the drain hose into drainpipe or standpipe.
4.5"
(114 mm)
4.5"
(114 mm)
Loading ...
Loading ...
Loading ...