Loading ...
8
Important information...
Your dryer is designed to be particularly energy efficient. Its technical features include
a refrigeration circuit, which uses energy efficiently in a similar way to a refrigerator.
The dryer's heat exchanger is cleaned automatically during drying.
The fluff filters and filter in the condensate container must be cleaned regularly.
Never operate the dryer without the fluff filters and without filter in condensate container!
ʑ
Fluff filters
During drying, fluff and hair from the laundry is trapped by the fluff filter. A blocked fluff filter
may impair the heat exchange process.
The fluff filters must therefore be cleaned after every drying cycle.
Rinse regularly under running water aPage 4.
When cleaning the fluff filter, make sure that no foreign material (down, filling material) enters
the air duct opening. If necessary, clean the drum beforehand with a vacuum cleaner.
If foreign material should still enter the air duct a call the after-sales service.
ʑ
Filter in the condensate container
The filter in the condensate container cleans the condensation. This condensation is required
for the automatic cleaning process. The filter should be cleaned regularly under running
water. Empty the condensate container before cleaning the filter a Installation and
maintenance instructions, Page 3.
ʑ
Fabrics
Do not dry any fabrics that have come into contact with solvents, oil, wax, grease or paint:
e.g. hair styling products, nail varnish remover, stain remover, cleaning solvent, etc.
Empty all pockets.
Do not dry non-breathable fabrics.
Avoid drying laundry items that produce a lot of fluff.
Woollens should be refreshed or dried using the woollens programme only.
9
Consumption rates
Fabrics/programmes
Residual moisture in the fabrics
after spinning
Drying time** Energy consumption**
LüCottons 9ükg
+cC/board dry* 1400ürpm 50ü% 133ümin 1.72ükWh
1000ürpm 60ü% 157ümin 2.13ükWh
800ürpm 70ü% 181ümin 2.48ükWh
|cIron dry* 1400ürpm 50ü% 98ümin 1.22ükWh
1000ürpm 60ü% 123ümin 1.62ükWh
800ürpm 70ü% 147ümin 2.00ükWh
IüEasy Care 3.5 kg
+cC/board dry* 800ürpm 40ü% 46ümin 0.52ükWh
600ürpm 50ü% 60ümin 0.66ükWh
For testing in accordance with applicable standard EN61121 the dryer shall be used
with external drain set.
* Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric, the degree of dryness that has been set
and the amount of laundry being loaded.
Fabrics/programmes Drying time Annual energy consumption
LüCottons 9ükg / 4.5ükg*
+cC/board dry*** 157 min / per cycle 258ükWh / per year
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
10
Normal noises
During drying, the compressor and the pump generate some noise which is entirely normal.
The compressor in the dryer may
occasionally generate a humming noise.
The volume and pitch of this may vary
depending on the selected
programmes and the progress of the
drying.
The compressor in the dryer is ventilated
from time to time, which creates a whirring
sound.
The automatic cleaning process causes
a clicking noise.
The process of pumping the condensation
into the condensate container generates
pumping noises.
11
What to do if ...
If you cannot rectify a fault yourself (e.g. by switching the dryer off/on), please contact our
after-sales service.
We will always find an appropriate solution and will avoid unnecessary visits by engineers.
Trust the expertise of the manufacturer and rest assured that the repair will be carried out by
trained service technicians using original spare parts.
The contact details of your local after-sales service can be found in the enclosed after-sales
service directory:
– GB 0344 892 8979 (Calls charged at local or mobile rate.)
– IE 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.)
When contacting the after-sales service, please specify the product number (E-Nr.)
and production number (FD) of your appliance(see inside of door).
Switch the dryer off using the programme selector and unplug the mains plug from
the socket.
ʠ
Please empty condensate
container is displayed.
Emptying the condensate container aPage 4.
Press any button.
Press the $Start/Pause button again.
ʠ
Please empty condensate
container is displayed and the
drying cycle is interrupted.
Is the condensation drain installed? aCondensation
drain hose blocked a check and clean the hose.
Stopper in the condensate container? aseparate
Instructions for condensation drain.
Is the filter in the condensate container dirty? aClean
the filter in the condensate container aInstallation
and maintenance instructions, Page 3.
ʠ
Residual water in
the condensate container
despite the dryer being
connected to the condensation
drain.
Not a fault. If the condensation drain is installed, residual
water remains in the condensate container due to
the dryer's self-cleaning function.
ʠ
Please clean lint filter is
displayed.
Clean the fluff filters aPage 4.
Press the $Start/Pause button again.
ʠ
Dryer does not start. Has the $Start/Pause button been pressed?
Door closed?
Ambient temperature greater than 5°C?
ʠ
Water is leaking out. Make sure the dryer is level.
Push the condensate container back in until it locks fully
into place.
12
What to do if ...
ʠ
Laundry is not dried correctly or
is still too damp.
After the end of the programme, warm laundry feels
damper than it actually is. Spread the laundry out and allow
the heat to disperse.
Finely adjust the dryness level – this extends the drying
time but does not increase the temperature. Your laundry
will become drier.
Select a programme with a longer drying time or increase
the drying level. This does not increase the temperature.
Select a time programme for extended drying of laundry
that is still damp.
If you have exceeded the maximum load for the
programme, the laundry may not be dried correctly.
Clean the moisture sensor in the drum. A fine layer of
limescale may adversely affect the performance of
the sensors and your washing will not dry properly.
Drying has been interrupted as a result of a power cut,
because the condensate container is full or because
the maximum drying time has been exceeded.
ʠ
Drying time too long. Clean the fluff filters under running water a Page 4.
Insufficient supply of air a Ensure that air can circulate.
Air inlet may be obstructed? Clear the inlet
aInstallation and maintenance instructions, Page 1.
Ambient temperature higher than 35 °C a Ventilate
the room.
ʠ
The humidity in the room
increases significantly.
Make sure the room is sufficiently ventilated.
ʠ
Heat exchanger is being rinsed
is displayed in the display panel.
Not an error. Automatic cleaning of the heat exchanger.
Do not empty the condensate container during
the cleaning process.
ʠ
Power failure. Remove the laundry from the dryer immediately and
spread out. This allows the heat to dissipate. Be careful as
the door, the drum and the laundry may be hot.
ʠ
Other intermittent noises and
vibrations.
Normal noises aPage 10.
13
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
dryer...
– in rooms inside the house.
– to dry fabrics.
The dryer must
NEVER...
– be used for purposes other than those described above.
– be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been instructed
in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets, and lighters in particular aRisk of explosion.
– Do not lean or sit on the door a Risk of tipping.
– Open the door carefully. Hot steam may escape. Fabrics and drum may be hot
a Risk of burns.
Installation
– Secure loose leads or hoses, otherwise there is a risk of tripping.
– Below 0 °C there is a possibility of frost damage.
Mains
connection
– Connect the dryer to an AC earthed socket according to specifications, otherwise
it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
– Do not touch or hold the appliance plug with wet hands a Risk of electric shock.
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead a Risk of electric shock.
Operation
– Only load the dryer as recommended in the programme descriptions
(Programmes/fabrics, Page 1 and Programme overview, Page 7) . Check
the contents before you switch the dryer on.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair styling products, nail varnish remover, stain remover,
cleaning solvent, etc.) a Risk of fire/explosion.
– The tumble dryer is not to be used if industrial chemicals have been used
for cleaning.
– Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer
a Risk of explosion.
– Do not put laundry containing foam material/rubber in the dryer aelastic material
may be destroyed and the dryer may be damaged due to possible deformation
of the foam material.
– Do not turn off the dryer until the drying process ends, unless the laundry will be
removed quickly and spread out, so that the heat can dissipate.
– Light things, such as long hair, may be sucked into the air inlet of the dryer
aRisk of injury.
– Final part of a tumble dryer cycle occurs without heat (cool down cycle), to ensure
that the items are left at a temperature that ensures that the items will not be
damaged.
– Switch off the dryer once the programme has ended.
– The distilled water/water from condensation is not drinking water and may be
contaminated with fluff.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer if the mains cable is defective. To avoid danger, only have
the defective mains cable replaced by the after-sales service.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Disposal
– Dryer: Pull out the appliance plug, then cut off the mains cable from the appliance.
Dispose of the appliance at a municipal waste disposal facility.
– Packaging: Keep all packaging out of reach of babies and children
a Risk of suffocation.
– The dryer's heat exchanger contains fluorinated greenhouse gas (R407c)
in a hermetically sealed unit a Dispose of this properly. Capacity: 0.290 kg.
– All materials are environmentally sound and can be reused.
Dispose of in an environmentally-responsible manner.
en operating instructions
Dryer
WTY88701AU
Loading ...
Loading ...
Loading ...