Instruction booklet
TUMBLE DRYER
WHERE TO INSTALL THE TUMBLE DRY-
ER
10
m
m
15 mm
15 mm
15 mm
15 mm
If you are going to install the
appliance under a work counter
be sure to leave a
10 mm space between the top
and any other objects on or
above the machine and a 15 mm
space between the sides and
any kitchen units or walls to
ensure proper air circulation. e dryer must never
be installed behind a lockable door, a sliding door or
a door with a hinge on the opposite side to that of the
dryer door.
e appliance must be installed with the rear surface
placed against a wall.
VENTILATION
When the dryer is in use there has to be adequate
ventilation to avoid the back ow of gases into the
room from appliances burning other fuels, including
open res. e vent tube should not exceed 2.4 metres in length.
e tube should be kept clear of the air intake vent and kinks or
‘U’ bends must be avoided as these will obstruct the tube and trap
condensation.
VENTING
Wall mounting
Keep the tube as short and as straight as
possible to prevent condensation forming
in the vent pipe.
e duct in the wall should slope slightly
downwards.
Mounting
e hole should be as low down as
possible and the tube should be kept as
short as possible. Depending on how oen you use your tumble dryer,
is symbol reminds you to read this booklet.
B
A
it is essential that areas A and B are checked periodically to remove
lint or debris. Make sure that the ventilation hose, air inlet vents, and
outlets are not obstructed or blocked.
Venting
e end of the tube should be directed downwards, to prevent warm
moist air from condensing in the room or dryer.
Do not discharge exhaust air into a ue which is used
for exhaust fumes from other appliances that burn
gas or other fuels.
Do not discharge exhaust air into an extraction system or any duct
with an extractor fan. is will aect the way the thermal controls
operate and can result in a re hazard.
ELECTRICAL CONNECTIONS
e socket must be grounded. e power supply cord
should be checked periodically. If the supply cord is
damaged, it must be replaced by the manufacturer,
its service agent or similarly qualied persons in
order to avoid a hazar
LEVELLING YOUR DRYER
e dryer must be installed level for correct operation. When you have
installed your dryer in its nal location check that it is rst level side to
side and then back to front.
If the dryer is not level use a wooden block to support it while
adjusting the two front legs up or down until your dryer is level.
BEFORE YOU START
USING YOUR DRYER
Once you have installed your
dryer and before you use it
clean the inside of the drum to
remove any dust that could have
accumulated during transport.
Air intake vent
Do not block or obstruct
Caution: Hot!
Vent Tube tted here
Power consumption
o-mode (Po) - Watts 0.00
left-on mode (Pl) - Watts 0.00
Programs Kg kWh Minutes
Standard cotton*
7 4.08 113
Standard cotton
3.5 2.10 64
Synthetics 3 1.11 40
* This is the reference program for the energy label
and suitable to dry normal wet cotton laundry. This
is the most ecient programme in terms of energy
consumption for drying wet cotton laundry.
ITEMS NOT SUITABLE FOR TUMBLE
DRYING
1. Articles that contain rubber or rubber-like materials or plastic lm,
any ammable articles or objects that contain ammable substances.
2. Glass bres.
3. Items which have been dry cleaned.
4. Large bulky items (quilts, sleeping bags, etc). ese expand when
drying and prevent airow through the dryer.
Loading ...
Loading ...
Loading ...
