Loading ...
Loading ...
Loading ...
9www.sharkclean.com
English
11
Proper Care of Your Shark
®
Upright Vacuum
COMPONENT
MAINTENANCE SCHEDULE
Rinse and air dry every month under normal use.
Empty each time you vacuum.
Pre-MotorFoamFilters(2)
Dust Cup
Rinse and air dry every month under normal use.
Pre-MotorFeltFilter
Clean once every 12 months under normal use.
Post-MotorFilter
1
2
3
4
DO NOT operate the vacuum without ALL the filters in place.
DO NOT operate the vacuum with WET filters.
IMPORTANT: Loss of Suction may occur
if foam filters are not cleaned every month. Rinse
and allow to air dry completely. Tap loose dirt
from foam filters as needed in between washing.
Foam filters may appear dirty after use - this is
normal.
To clean the pre-motor filters:
1 Remove the dust cup.
2 Pull the filter frame with the pre-motor filters out
from the top of the motor base.
3 Remove the filters from the filter frame and tap
the loose dirt from the foam filters in between
washing as needed.
4 Rinse the filters thoroughly in lukewarm water until
the water runs clear.
DO NOT put the filters in the washing machine or
dishwasher.
NOTE: The material in the filters will discolor
overtime.ThisisNORMALandwillnotaffectthe
performance of the filters.
5 Squeeze out excess water and let air-dry for at
least 24 hours before replacing. Do not use a hair
dryer or other heating methods to dry.
6 Place the felt filter in first, then the foam filter.
7 Replace the dust cup.
To clean the post-motor filter:
1 Remove the filter cover from the front of the
vacuum by pulling up on the tab and pulling the
cover away from the vacuum.
2 Take out the filter by pulling it straight out.
3 Turn the filter over so that the dirty side is on
the bottom and vigorously tap it clean against a
garbage can to remove any dust.
4 Wash the filter under the tap using lukewarm
water with the dirty side face down until the water
runs clear.
DO NOT put the filter in the washing machine or
dishwasher.
NOTE: The material in the filter will discolor over
time.ThisisNORMALandwillnotaffectthe
performance of the filter.
5 Allow the filter to air dry for 24 hours. Do not use a
hair dryer or other heating methods to dry.
6 Once the filter is dry, replace it back into the
vacuum.
7 Replace the cover by inserting the two tabs into
the holes at the bottom and then swinging the
cover up until it clicks into place.
Pre-Motor
Foam Filter
Foam Filter
Felt Filter
Filter Frame
Post Motor
Filter
Loading ...
Loading ...
Loading ...