Loading ...
Loading ...
Loading ...
en-us Operating the Dishwasher
36
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Press On/Off button (.
2.
Remove the dishes when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Press On/Off button (.
The LED’s go out. The wash cycle
is saved.
2.
To continue the wash cycle, close
the door and press On/Off button
( again.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
Terminating the wash cycle
(Reset)
Ter minating the wa s h cycl e
1.
Press and hold Start button P
for approximately 3 seconds until
the display reads ‹:‹‚.
2.
Wait about 1 minute while the
dishwasher drains.
3.
Press On/Off button (.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
InfoLight
®
While the wash cycle is running, a
light spot shines on the floor under
the appliance door.
Do not open the appliance door until
the light point is no longer visible on
the floor.
If the appliance door is not
completely closed, the light spot
flashes*.
If the appliance is installed at
eye-level, with flush furniture front, the
light point is not visible.
In darkened rooms, some light
scattering may be visible. This is
normal and cannot be changed.
You can switch the Infolight on or off.
To change the setting:
1.
Press the On/Off button (.
2.
Hold down function key # and
press Start button P until the
display 8 indicates š:‹x (x can
be any number). Release both
buttons.
3.
Press function key # until the
display shows ‚:‹‚.
‚:‹‹ Off
‚:‹‚ On
Loading ...
Loading ...
Loading ...