Table of Contents
Cause:
1.Dust bin doesn't install well.
2.Dust bin is taken out
Solution:
Re-install dust bin and slightly press dust bin
Cause:
1.Robot is picked up or suspended in the air.
2.Anti-drop sensor is dirt.
3.Robot is on the black carpet which anti-drop sensor feel black carpet is cliff.
Solution:
1.Please move robot to a flat surface and restart robot
2.Clear Anti-Drop Sensor by Damp cloth as * 4.5 Clean Sensor and Charging Contracts at page 35
3.Use supplied boundary strips to block robot walk onto black carpet
4 Restart robot as “3.13 Restart Robot" in page 31
5. If still have error. please contact [email protected] for assistant.
Cause:
1.Robot is blocked or placed in a high place.
2.Anti-drop sensor is dirt.
Solution:
1. Please move the robot to a flat surface and restart robot
2.Clear Anti-drop sensor by damp cloth.
Cause:
Robot Navigation module is malfunction
Solution:
Restart robot as "3.13 Restart Robot " in page 31
Cause:
Front bumper is stuck.
Solution:
Please gently press the left. middle and right part of the bumper to check| nether it can pop out
If still have error. please contact [email protected] for assistant
Cause:
The suction inlet of your robot is being blocked.
Solution:
1.Power off the robot. then remove and empty the Dust Bin.
2. Make sure there is no hair or debris blocking the suction inlet
Cause:
Robot is stuck or trapped
Solution:
Clear any obstacles in the surrounding area or move robot to jan open ground before starting.
Cause:
1.Left or right wheels may be stuck or entangled with foreign objects inside wheels.
2.Robot is stuck by foreign objects on the ground, which robot couldn't move
Solution:
1 .Power Off robot. turn over robot. Use hand to push wheels and rotate} wheels to check if there is foreign objects inside wheels.
2. Move robot to open space
Cause:
Main brush may be stuck or entangled with foreign objects.
Solution:
Power Off robot and take off main rush guard. please clean main brush as “4.3 Clean Main Brush" in Page 34
Cause:
Side brush may be stuck or entangled with foreign objects.
Solution:
Power off robot. then please check he side brush and remove the foreign objects as “4.4 Clean Side Brush” in Page 35
Cause:
1.Robot can't find charging station.
2.Charging station isn't powered on.
Solution:
1.To check if charging station is powered and power indication on charging station is on.
2.Put robot onto charging station
T: @ManualsFile
https://ManualsFile.com
Mon - Sun 09:30 am - 05:30 pm