Loading ...
Loading ...
Loading ...
49-3000193 9
ENGLISH
CARE AND CLEANING
Exterior
Wipe or dust any spills or washing compounds with a damp cloth. Dryer control panel and finishes may be damaged by some
laundry pretreatment soil and stain remover products. Apply these products away from the dryer. The fabric may then be
washed and dried normally. Damage to your dryer caused by these products is not covered by your warranty.
Stainless Steel
To clean stainless steel surfaces use a damp cloth with a mild, non-abrasive cleaner suitable for stainless steel surfaces.
Remove the cleaner residue and then dry with a clean cloth.
The stainless steel used to make the dryer drum provides the highest reliability available in a Haier Appliances dryer. If the
dryer drum should be scratched or dented during normal use, the drum will not rust or corrode. These surface blemishes will
not affect the function or durability of the drum.
Interior
The interior of the appliance should be cleaned once a year by qualified service personnel.
Lint Filter
Clean the lint filter before each use.
Pull out the lint filter. Moisten your fingers and remove the captured lint. Once clean, slide the
filter back into position. Have a qualified technician vacuum the lint from the dryer once a year.
NEVER OPERATE THE DRYER WITHOUT ITS FILTER IN PLACE.
Drum Lamp
NOTE: The drum lamp is not consumer replaceable on models where there is a flat cover over an LED bulb. If this light should ever
stop working, contact us for service.
For models that have a domed cover over the bulb secured by a screw:
Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the
household distribution panel by removing the fuse or switching off the circuit breaker. Reach above
dryer opening from inside the drum to locate the light.
Remove the screw and the plastic cover to access the bulb. Replace with the appropriate bulb and
then reaffix the cover and screw.
Order replacement bulb WE11X26351 by visiting our website at haierappliances.com/parts or in Canada visit haiercanada.ca/parts.
You may also purchase appliance bulb 7C7 from your local retailer.
When the door is opened, the drum lamp automatically turns on and remains on for 2 minutes. When the door is closed, the drum
lamp will remain on for 30 seconds.
Disconnect power supply before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
- Shock Hazard
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing.
Service personnel – DO NOT contact the following parts while the appliance is energized: motor start capacitor, motor
metal holder, and drum wheel shaft.
- Electrical Shock Hazard
WARNING
Loading ...
Loading ...
Loading ...