Loading ...
Loading ...
Loading ...
24 49-3000193
ENGLISH
TROUBLESHOOTING TIPS
Problem Possible Cause What To Do
Dryer shakes or
makes noise
Some shaking/noise is normal.
Dryer may be sitting unevenly.
Move dryer to an even floor space, or adjust leveling legs as necessary
until even.
Clothes take too
long to dry
Improper sorting Separate heavy items from lightweight items (generally, a well-sorted
washer load is a well-sorted dryer load).
Large loads of heavy fabrics
(like beach towels)
Large, heavy fabrics contain more moisture and take longer to dry.
Separate large, heavy fabrics into smaller loads to speed drying time.
Non-venting dryer Condensing dryers usually take longer to dry than a vented dryer.
Controls improperly set Match control settings to the load you are drying.
Condenser box is clogged Remove and clean the condenser box. Also, clean the location where
the condenser box is located ensuring all seals are free from debris.
Put the condenser box back and lock it in place. See Condenser in the
Care and Cleaning section.
Lint filter is full Clean lint filter before every load.
Blown fuses or tripped circuit
breaker
Replace fuses or reset circuit breakers. Since most dryers use 2 fuses/
breakers, make sure both are operating.
Overloading/combining loads Do not put more than one washer load in the dryer at a time.
Underloading If you are drying only one or two items, add a few items to ensure proper
tumbling.
The Dry dryness
level was chosen
but load is still
damp
Load consists of a mixture of
heavy and light fabrics
When combining heavy and light fabrics in a load, choose More Dry.
Lint filter, condenser, and/or air
intake vent located on the front
of the dryer is blocked
Inspect and clean lint filter, condenser, and/or air intake vent located on
the front of the dryer.
Dry Sensor is dirty Clean the sensor with a moist cloth.
Control buttons
not responding
Controls accidentally put in
service mode
Press Start/Pause.
Controls accidentally put in
lock mode
Hold the Lock Control button for 3 seconds to unlock the dryer.
Controls performed an
incorrect operation
Reset the in-house breaker.
Dryer doesn’t
start
Control panel is “asleep” This is normal. Press Power to activate the control panel.
Dryer is unplugged Make sure the dryer plug is pushed completely into the outlet.
Fuse is blown/circuit breaker is
tripped
Check the building’s fuse/circuit breaker box and replace fuse or reset
breaker. NOTE: Electric dryers use two fuses or breakers.
Dryer was accidentally paused
when starting Delay Dry
If the light on the Start/Pause button is flashing, the dryer is paused.
Press Start/Pause to restart the countdown.
Water tank is full If the Empty Tank light is on, you must empty the water tank before the
dryer will start. Refer to the Care and Cleaning section for instructions
on emptying the water tank.
No numbers
displayed during
cycle, only lights
Dryer is continuously
monitoring the amount of
moisture in the clothes
This is normal. When the dryer senses a low level of moisture in the load,
the dryer will display the dry time remaining.
Loading ...
Loading ...
Loading ...