Loading ...
Loading ...
Loading ...
49-3000193 21
ENGLISH
INSTALLATION INSTRUCTIONS
INSTALLING THE STACK BRACKET KIT
INSTALL DRYER AND BRACKET ON
DRYER
A. Lift the dryer on top of the washer. Protect the
washer control panel with cardboard or other
protection. Be sure to lift the dryer high enough to
clear the washer control panel.
B. Align the holes in the bracket with the holes in the
back of the dryer. Using a Phillips screwdriver, attach
the 2 #8 x 1/2” tapping screws.
2
Failure to do so may result in back or other injury, or
property damage.
Use two or more people to install dryer.
Avoid tipping and rupture of utility services.
Dryer must be securely attached to the washer.
DO NOT place the washer on top of the dryer.
WARNING
- Excessive Weight
Hazard
Disconnect power before installing.
Failure to do so could result in
serious injury or death.
WARNING
FINALIZE THE INSTALLATION
A. Refer to the washer Installation Instructions to
complete the washer installation.
B. Refer to the dryer Installation Instructions to
complete the dryer installation.
C. Carefully slide or walk the stacked washer and dryer
into place. Use felt pads or other sliding device to
assist moving and to protect flooring.
3
Do not push on the dryer once
installed to top of the washer.
Pushing on the dryer may result in pinched fingers.
CAUTION
INSTALL BRACKET TO WASHER
A. Remove washer top cap screw from the rear left.
Align left bracket holes with top cap screw hole on
rear left of the unit and replace screw.
NOTE: Leave screws loose so dryer hole alignment
will be easier.
B. Drive next screw through the bracket into the rear
of the washer.
C. Repeat the above steps with the right side.
1
INSTALL DRYER AND BRACKET ON
DRYER (CONT.)
C. Tighten the dryer bracket screws; then tighten all
stacking kit screws.
2
Washer
Top
Short screws into
brackets and washer
Long screws into
brackets and dryer
Place
hands
here
Place
hands
here
Washer
Dryer
Loading ...
Loading ...
Loading ...